Your search resulted in 544 documents. Displaying 25 entries per page.
A novel method for assessing radial variation in termite resistance of timber
2023 - IRG/WP 23-11005
Australia has many timbers whose heartwood is highly resistant to fungal and termite attack; however, changing public policies have resulted in restricted access to many native forests where these species are found. Plantations of these same species are expected to replace these resources, but there are questions concerning whether timber from these trees will have the same resistance as the nati...
S Kleinschmidt, R McGavin
Japanese traditional wooden building construction project in Bangkok - Part 2 Verification of termite control method
2023 - IRG/WP 23-11022
We have confirmed the effectiveness in Thailand of chemicals and stainless steel mesh that have been proven effective in Japan.
Stake and container tests were conducted and the following results were obtained:
1. There is no damage on specimens covered with stainless steel mesh, CuAz-treated specimens both stake test and container test.
2. Natural pyrethrin-treated specimens without stainless ...
H Ishiyama, S Murakami
Mini-stakes – an alternative test method for EN 252?
2023 - IRG/WP 23-20691
Market approval of wood treatment products requires knowledge and prove of long-term durability. Efficiency of wood treatment with a specific product is evaluated based on variety of tests, including penetration evaluation, leaching studies as well as decay tests. EN 252 standard test is a core method for wood durability evaluation in a ground contact, both for commercial product approval and scie...
R Digaitis, P Larsson Brelid, N Terziev, M Klamer, A W Christof, J Stenaek, N Morsing
Field durability testing of wood above ground - Part 1: 15 years’ experience with the Bundle method
2023 - IRG/WP 23-20695
A ‘jack of all trades’ method for above-ground wood durability testing has been sought for decades, but until now no method has found its way into standardization. The method of choice shall be applicable for untreated and treated wood – ideally also for wood composites. It shall be reproducible, objective, fast, easy, and inexpensive. Finally, it shall provide high predictive power.
This s...
C Brischke, G Alfredsen, L Emmerich, M Humar, L Meyer-Veltrup
Field durability testing of wood above ground - Part 2: The full guideline of the Bundle method
2023 - IRG/WP 23-20696
To determine the biological durability of wood above ground, numerous approaches for test methods have been pursued and tried out in the field in the past. So far, no method has managed to find its way into a European standard. During the last 15 years, experience with the Bundle method has been gained. As described in Part 1 of this paper, the method is recommended as a suitable tool for determin...
C Brischke, G Alfredsen, L Emmerich, M Humar, L Meyer-Veltrup
A simple method for assessing the effects of lyctid beetle attack on longitudinal compressive strength of spotted gum sapwood
2023 - IRG/WP 23-20700
Lyctid beetle attack is commonplace in a significant proportion of spotted gum utility poles that are air seasoned prior to chromated copper arsenate (CCA) treatment. While this damage is allowed, there are no reports quantifying the effects of the beetle galleries on pole properties. Full scale testing would require substantial quantities of poles in order to obtain a range of degrees of damage....
M Powell, J J Morrell
Geopolymer as a fixation method for tannin-based wood preservatives
2023 - IRG/WP 23-30774
This study aims to test if a second step impregnation with a geopolymer solution can fix Colatan GT10, a commercial extract rich in tannins, to wood, reducing their leaching and improving their performance as wood preservatives. Scots pine sapwood specimens of 40×10×5 mm3 were impregnated with Colatan GT10 tannin mix, geopolymer, and as combined treatment Colatan GT10 with subsequent geopolymer ...
Y M López-Gómez, A Barbero-López, A Haapala
Resistance of phenol formaldehyde impregnated beech (Fagus sylvativa L.) LVL against biodegradation in soil contact
2023 - IRG/WP 23-40965
Alternatives to preservative impregnation are emphasized in Germany and other European countries. Even though these treatments significantly improve wood's resistance to decay, they often do not have a beneficial impact on the dimensional stability. One alternative product, which may be used in ground contact for items like poles and railway sleepers, could be beech (Fagus sylvatica L.) laminated ...
M Slabohm, C Brischke, S Bicke, H Militz
Laboratory and field evaluations of bio-based termiticide containing Arnica extract from Berkem Biosolutions® against native and Formosan subterranean termites
2024 - IRG/WP 24-11049
Arnica extract from Berkem Biosolutions® is a 100% plant-based ingredient, rich in active molecules, particularly polyphenols, specially adapted to the needs and challenges of termite protection. The efficacy performance of a bio-based termiticide product containing Arnica extract from Berkem Biosolutions® had been evaluated both in soil treatment and in wood protection treatment against native ...
D Messaoudi, J Curole, Q Wu
Modelling the service life of wood in ground contact – Verification of remotely sensed soil data from the reanalysis dataset ERA5-Land using in-situ measurements at a test site of utility poles in Eastern Norway
2024 - IRG/WP 24-41003
This study compared soil moisture and temperature estimates from the 5th European reanalysis (ERA5-Land) dataset with in-situ measurements to assess the accuracy and applicability of ERA5-Land data for modelling the service life of wood in ground contact. The ERA5-Land soil temperature estimates showed a moderate correlation with the in-situ temperature measurements (Spearman’s ρ of 0.73) and a...
U Hundhausen, P B van Niekerk, B Marais
Performance of Douglas-fir cross laminated timber (CLT) subjected to elevated humidity in a ground proximity field test for 6 years
2024 - IRG/WP 24-41010
The ability of insecticidal soil drenches or spray-on insecticide/fungicide treatments to protect mass timber elements exposed in a high moisture environment but out of direct soil contact was assessed using a modified AWPA ground proximity test established in 2017. Three-ply Douglas-fir CLT pieces measuring 305 x 355 x 105 mm (L x H x W) were installed at the Harrison Experimental Forest (HEF) (S...
M E Mankowski, J J Morrell, T G Shelton, G T Kirker
Field test method for wood in above ground situation - The full CEN/TC 38 guideline for the Sandwich method. Part 1 - Determining the relative protective effectiveness of a wood preservative
2024 - IRG/WP 24-41013
The attached draft CEN Technical Specification (i.e. pre-EN standard) has been drafted in order to become an alternative to the Lap-Joint test method (EN 12037:23) for testing of wood in above ground situation and the draft CEN/TS Part 1 is specifically intended for determining the relative protective effectiveness of a wood preservative. The new draft CEN/TS is based on a test method developed by...
M Westin, R Ringman, A Christof, F Friese
Fungal degradation of oak timber bridges
2025 - IRG/WP 25-11058
Wood is increasingly recognised as an eco-friendly building material, but its organic nature makes it vulnerable to degradation, especially in outdoor applications exposed to moisture. This study investigates wood-decaying fungi affecting oak timber bridges in Hanover, Germany. The study aimed to identify the fungal species using culture-independent methods and to examine the impact of poorly exec...
L Schrader, J Trautner, C Brischke
Evaluating the Efficacy of Arnica Extract-Based Termiticide from Berkem Biosolutions® in Subterranean Termite Control: A Comprehensive Laboratory and Four-Year Field Study
2025 - IRG/WP 25-20731
Subterranean termites pose significant threats to wooden structures. This study evaluated the efficacy of a bio-based termiticide product containing Arnica extract from Berkem Biosolutions® in controlling subterranean termites in both laboratory and field conditions. The laboratory assessments utilised “the Bottle H” test unit, adhering to the Japan Wood Preservation Association (JWPA) standa...
D Messaoudi, S Khoirul Himmi, D Tarmadi, I Guswenrivo, S Yusuf
The spread of technology in a simple wooden pile construction method to prevent shallow landslides
2025 - IRG/WP 25-20733
This study introduces the development and practical application of an innovative slope stabilization technique called the Wood Pile Root System Method (WPRSM), aimed at preventing shallow landslides, which have increased due to the rising occurrence of extreme weather events caused by climate change. This method effectively reinforces slopes using thinned timber, providing a sustainable and cost-e...
K Shimizu, K Tanaka, H Hashitani, A Yamaguchi, K Kabeno, Y Iijima, A Ito, M Jo, T Fujii, K Abe, H Ochiai
Improvement and practical application of dry-type pressure treatment method
2025 - IRG/WP 25-20734
In years, the need for environmental consideration has been reaffirmed worldwide, and in Japan too, there is a demand for the expansion of the uses of wood in order to achieve a decarbonised society. So, there is also a need to develop and improve wood preservation treatment methods that overcome the weaknesses of wood and enable it to be used in a wide range of applications. The authors have impr...
D Tezuka, C Igarashi
Enhancing the Fire Resistance of Spruce Wood through Treatment and Additive Application: Small Flame Test Method
2025 - IRG/WP 25-20737
Spruce panels treated by spraying with Burnblock® spray, were tested using “Small flame test method” according to EN ISO 11925-2:2011. The fire retardant product from Burnblock ApS is reported by the Danish company to be bioderived and non-toxic. The results for the untreated planed spruce showed moderate flammability whereas the Burn Block treated panels exhibited exceptional fire resistance...
E S Mujanic, R Hasanagic, E Kerzic, L Fathi, M Humar
Validation of a measurement method for cyproconazole retention in pressure-treated wood through an interlaboratory study
2025 - IRG/WP 25-41037
The Japanese Agricultural standard (JAS) defines national regulations for preserved wood and wooden materials, in Japan. Traditionally the JAS focused on quality of product, however, the revision of the JAS Act in 2017 enabled standardisation of test or measurement method for the quality evaluation. The Japan Wood Protection Association (JWPA) has been working toward standardisation of methods for...
T Miyauchi, Y Itou, M Samejima
Migration of polycyclic aromatic hydrocarbons (PAHs) in soil from creosote-treated Douglas-fir and southern pine posts in the first 12 months since installation
2025 - IRG/WP 25-50404
Creosote is a widely used industrial wood preservative largely used for infrastructure-related applications such as utility poles, railway ties, and in marine pilings for protection against fungi, insects, and marine wood borers. Creosote is a coal tar distillate consisting of a complex mixture of organic compounds that together function as a biocide. Polycyclic aromatic hydrocarbons (PAHs) are th...
K Quigley, G Presley