Your search resulted in 997 documents. Displaying 25 entries per page.
Improvement and practical application of dry-type pressure treatment method
2025 - IRG/WP 25-20734
In years, the need for environmental consideration has been reaffirmed worldwide, and in Japan too, there is a demand for the expansion of the uses of wood in order to achieve a decarbonised society. So, there is also a need to develop and improve wood preservation treatment methods that overcome the weaknesses of wood and enable it to be used in a wide range of applications. The authors have impr...
D Tezuka, C Igarashi
Securing Flame Retardancy in Wood: Durability After Artificial and Natural Weathering Test
2025 - IRG/WP 25-20738
The outdoor use of wood is often limited by challenges such as dimensional instability, vulnerability to fungal decay, and high flammability. Traditional flame retardant treatments improve fire resistance but suffer from significant leaching under environmental exposure, reducing their long-term effectiveness. This study introduces an innovative solution by integrating flame retardants with DMDHEU...
M Wu, L Martin, H Militz
CIOL Wood - Scientific Innovations in Wood Modification for Enhanced Performance and Usage
2025 - IRG/WP 25-20743
CIOL® is a wood modification technology designed as an environmentally friendly alternative to traditional wood preservatives. Utilising a biobased formulation based on sorbitol and citric acid, CIOL® enhances wood's chemical structure, improving its durability, stability, and resistance to decay. This paper provides an overview of the advancements made in CIOL® technology, including its improv...
E Larnøy, A Treu, M Diraison, M Smith, A Audouin, P T Lewandowski, J Biørnstad
Evaluation of 'Deep Penetration Treatment' for wood preservation
2025 - IRG/WP 25-20746
‘Deep Penetration Treatment’ (DPT) is a recently developed wood preservation technique in Japan designed to meet the preservation standards required for residential foundations. This method involves spraying a specially formulated solvent-borne wood preservative onto properly incised dried lumber. Despite being a non-pressure treatment, DPT achieves penetration levels comparable to conventiona...
M Ikeda, T Shigeyama, Y Sugai
The iTrussT project – Advancements in timber bridge design, preservation, and monitoring
2025 - IRG/WP 25-20751
The Norwegian research project iTrussT (2025–2028) aims to advance timber bridge design and unlock wood’s full potential as a sustainable solution for modern infrastructure. It addresses three critical challenges: First, fatigue testing of glued laminated timber lamellae will provide deeper insights into shear failure mechanisms, supporting the development of safer, more efficient structures a...
K-C Mahnert, U Hundhausen
Durability Analysis of Bio-based Phenol-Formaldehyde Resin-Treated Wood
2025 - IRG/WP 25-20753
The aim of this study is to explore the application of bio-based materials in outdoor construction. Enhancing the durability of wood products effectively extends their carbon storage lifespan, making it essential to investigate their long-term durability. The study used commercial resin (CPF) and laboratory-synthesised petro-based phenolic resin (LPF) as control groups. Japanese cedar specimens we...
T-H Lin, P-Y Kuo
Curing Behaviour of Bio-based Phenol Formaldehyde Resin and the Durability Performance of Treated Wood
2025 - IRG/WP 25-20758
The aim of the study is to investigate the curing behaviours of bio-based PF resins treated Japanese Cedar (Cryptomeria japonica). Compared to conventional wood preservatives such as metal-based ACQ, bio-based PF resin was more environmentally-friendly and can store more plant-based carbon inside treated wood. However, all these preservatives have the risk of being leached out. This study conducte...
Y-S Lee, P-Y Kuo
Chestnut tannin-furfurylic resins for wood preservation: influence of the proportion of tannins as a copolymer
2025 - IRG/WP 25-30816
Tannin, which is present in all plants, is the most abundant polyphenol globally and can be extracted using water or organic solvents such as acetone, ethanol and methanol. Tannins are classified into two categories: condensed tannins (catechin-based polymers) and hydrolysable tannins (sugar esters with galloyl units). Previous studies have demonstrated its potential as a raw material for modifyin...
J V Dorini-Falavinha, C Gerardin-Charbonnier, P Cademartori
Enhanced Termite Resistance of Low Durability Fast Growing Teak Wood by Non-Biocide Treatments Based on Chemical and Thermal Modification
2025 - IRG/WP 25-30818
Short rotation teak as a fast-growing tree can be considered as a renewable material resource for the future green economy. However, short rotation teak wood is susceptible to biodeterioration, particularly to termite attack. The objective of this work was to investigate the effect of chemical and thermal treatment on resistance of sapwood, transition wood, and heartwood of short rotation teak aga...
R Martha, K Candelier, M-F Thévenon, B George, I S Rahayu, W Darmawan, P Gérardin
Unlocking the Potential of Dairy Coproducts in Wood Modification
2025 - IRG/WP 25-30822
The production of dairy coproducts, such as whey (sweet or acid) and whey ultrafiltration permeate, has significantly increased in response to the rising global cheese consumption. Proteins found in by-products are purified for human nutrition. However, upcycling lactose, which is the major compound of cheese by-products, is more challenging due to the high cost of upcycling processes. Furthermore...
A Keralta, J Karthäuser, J Winninger, J Chamberland, M-J Dumont, V Landry, H Militz
Mineral-wood composites with improved fire properties and durability prepared through MgCO3-based mineralization
2025 - IRG/WP 25-30823
New mineral-wood composites that demonstrate improved fire properties and higher resistance to selected fungi have been prepared using an environmentally-friendly mineralisation process involving impregnation with an aqueous magnesium acetoacetate solution. MgCO3-based compounds are formed in situ, deep within the wood’s structure. We show that the new mineralisation method overcomes wood’s lo...
A Pondelak, N Knez, S D Škapin, M Humar, A S Škapin
Preservation conditions of wooden roofs of two historical churches in middle-Sweden
2025 - IRG/WP 25-41016
Assessment of biodegradation by the rot of shingles from the roofs of churches of Hammarby and Tångeråsa in mid-Sweden was done by studies with X-ray computer tomography. The study suggests that inner rot could be detected with CT, which was not always easily detected by visual inspection. In some cases, erosion from the weathered side was fairly large, but the inner wood part was found not to b...
O Karlsson, Y Huang, A Postovoitova, C-F Lin, O Myronycheva
Experimental characterizing of liquid water uptake and release – key to understand moisture-induced decay risk analysis
2025 - IRG/WP 25-41020
Wood can absorb water vapour (sorption) or liquid water (capillarity). Moisture from liquid water (rain, spray water) is often a problem for the performance of wood products used in outdoor structures. Wood is prone to biodegradation when is it too moist for too long periods. Experimental studies that allow conclusions to be drawn about the practical use of wood water uptake are limited due to the...
M Nopens, J T Benthien, J Trautner, C Brischke
Evaluation of moisture exclusion ability of wood using double-layer outdoor exposure tests
2025 - IRG/WP 25-41021
The material resistance of wood to decay must be due to the combined effects of heartwood extractives and the moisture content state. Evaluating the moisture exclusion ability of wood is important for assessing its durability in outdoor use. We conducted previously double-layer outdoor exposure tests and investigated the relationship between moisture content over time and the progress of decay usi...
T Osawa, R Noda, K Yamamoto
mpact of Fence Post Footings on Wood Post Durability
2025 - IRG/WP 25-41025
Residential wood fence posts may be dug directly into the ground, secured to a metal spike that goes into the ground, or secured to a concrete footing with a metal boot. It was hypothesised that by keeping wood posts out of the ground both spikes and boot attachments would increase protection against decay and termites and extend the service life of the post. After 9-years of exposure in Kincardin...
D Wong, R Stirling
Durability and service life of wood in constructions. The Spanish approach of European Standard EN 460
2025 - IRG/WP 25-41028
The durability of wood is an important factor to be considered in the construction influencing in final durability and expected service life of a wood product in construction. There are many factors influencing in the durability (service life) of a wood in construction: Natural durability of wood species, preservative treatments and protection by design; combined with the variability of environmen...
D Lorenzo, J Fernández-Golfín, M Touza, A Lozano, J Benito
Quantitative Prediction of Latent Deterioration in Wood Coatings Using Mid-Infrared Spectroscopy and Machine Learning
2025 - IRG/WP 25-41038
Wood coatings play a vital role in prolonging the lifespan of timber structures by protecting them from environmental degradation. However, conventional evaluation methods rely on visual inspections, which cannot detect latent deterioration before visible damage occurs. This study integrates attenuated total reflectance-Fourier transform infrared (ATR-FTIR) spectroscopy with partial least squares ...
Y Teramoto
Considerations on how different preservation processing methods of logs would have different effects on wood structures
2025 - IRG/WP 25-41040
Azekura-zukuri style wood structures (hereinafter referred to as azekura-style structures) have been utilized in forest conservation projects in Japan as substitutes for concrete structures. We estimate that making use of thinned and small logs for azekura-style structures has positive impact on circular economy and carbon fixation and contributes to the biodiversity within their areas. In additio...
Y Iijima
Development of an Early Degradation Diagnosis Technology for Wood Coatings Using Mid-Infrared Spectroscopy and Machine Learning
2025 - IRG/WP 25-41047
Accurately predicting the degradation state of wood coatings is challenging, and as the coating deteriorates, it becomes a major factor accelerating the degradation of the wood itself. In this study, we aimed to develop a diagnostic technology that combines mid-infrared spectroscopy and machine learning to assess latent coating degradation, which cannot be detected visually, and to enable appropri...
K Nishimura, T Ito, S Isaji, T Takano, H Ohki, Y Teramoto
Durability Enhancement of US Hardwoods for Use in Open Trailer Decks
2025 - IRG/WP 25-41048
Apitong, a tropical hardwood derived from endangered species within Dipterocarpus genus, has long been used as a decking material for open flat-bed and lowboy trailers in the U.S. However, as more Dipterocarpus species are classified as endangered and critically endangered by International Union for Conservation of Nature (IUCN) due to the declining population of Apitong trees, there is a growing ...
X Xie, X Wang, G Kirker, C A Senalik
Bio-Based but Toxic? The Neglected Ecotoxicity of Leachates from Wood Preservatives—A mini-review
2025 - IRG/WP 25-50403
Bio-based Wood preservatives, derived from renewable biomass, are emerging as promising alternatives to traditional synthetic wood preservatives. Research groups all around the world are studying the development of bio-based – environmentally friendly – wood preservatives and their fixation to wood finding natural compounds with very promising wood preserving potential. However, there is a ver...
A Barbero-Lopez, A Haapala
Contribution of naturally durable wood use to Circular Economy - Understanding the classification system of natural durability and its variation within wood species
2025 - IRG/WP 25-50411
Total wood demand is shown by FAO to increase 49 percent between 2020 and 2050, regardless of deteriorating conditions such as deforestation and degradation due to fire and biological damages. Demand for wood as a building material is also projected by UNEP to increase significantly to 300 Gt in 2040. To address this situation, extension of the service life and re-use of wood are expected to make ...
K Yamamoto, T Osawa, R Noda