Growth of dark moulds enables the use of a decorative and protective biofinish for wood, showing advantages compared to traditional wood-coatings in terms of sustainability and self-repair. Based on the formation of a uniform mould covering on oil treated wood during outdoor exposure, the utilisation of a biofinish is in development. Basic information is lacking on the correlation between exposure site and biofinish formation on wood. To evaluate the impact of different locations, a biofinish assessment method was applied on different combinations of wood species and vegetable oil types after outdoor exposure in the Netherlands and Norway. Biofinishes were detected on wood samples made of spruce, pine sapwood and ilomba that were treated with olive oil and on pine sapwood treated with raw linseed oil after one and a half year of outdoor exposure in the Netherlands. More time was needed for biofinish formation on multiple wood-oil combinations for samples exposed in Norway. After two years of outdoor exposure three out of five wood-oil combinations that contained biofinishes in the Netherlands, showed similar results with the samples in Norway. Biofinish formation was not detected at all on untreated wood samples, regardless the wood species or exposure site. Loose fibres were observed on the surface of all untreated samples. It is likely that biofinish formation was prevented by the removal of stained fibres. Analysis of the stain coverage development on the wood samples, including initial stages of biofinish formation, showed a significant effect of exposure time and (oil) treatment on the stain coverage.

Download document (475 kb)
free for the members of IRG. Available if purchased.

Purchase this document