Your search resulted in 158 documents. Displaying 25 entries per page.
New experiences with Dry Rot in Danish buildings, heat treatment and viability tests
1989 - IRG/WP 1423
An increasing number of concealed dry rot attacks, especially in older multi-storey houses under renovation, have been detected during the last few years. A necessary consequence is a demand for cheaper methods of repair, compared to the standard method used in Denmark for many years otherwise severely attacked houses will by pulled down. A heat-treatment has been developed and tested in practice....
A P Koch, C Kjerulf-Jensen, B Madsen
Bending properties of wood after its decay with Coniophora puteana and subsequent modification with selected chemicals
1999 - IRG/WP 99-40146
Mechanical properties of wood are often decreased due to decay processes caused by biotic and/or abiotic factors. Damaged wooden elements (e.g. historical structures) can be reinforced by more methods, including their modification with convenient chemicals. This paper presents influences of selected chemicals on basic bending properties (modulus of elasticity - MOE, modulus of rupture - MOR) of so...
L Reinprecht, S Varinska
Preservative treatment of green timber by soaking in ammoniacal copper borate
1984 - IRG/WP 3292
Freshly sawn boards of radiata pine sapwood were preservative treated by soaking in ammoniacal copper borate. Optimum schedules were obtained by partially seasoning the boards for one week prior to treatment. This aided the absorption of preservative and reduced the required soaking time to approximately 2 hours. Complete boron penetration was obtained after one week of block storage under cover a...
P Vinden, A J McQuire
Detection of increased metal cations after wood decay using Chromeazurol-S
1997 - IRG/WP 97-20112
Chromeazurol-S (CAS) is a dye used for the spectrophotometric determination of metals, mainly aluminum (Al), berillium (Be) and copper (Cu). CAS has been widely used for determining the penetration of copper containing preservatives like CCA (AWPA A3-96). Additional uses include: i) detection of utility pole decay (Esyln, 1979), ii) a chemical spot test for aluminum in wood (Kukachka and Miller, 1...
F Green III, U Srinivasan, R B Miller
Effect of test site location on in-ground preservative performance after 6 years
2001 - IRG/WP 01-20231
Pinus radiata test stakes were treated with 4.1 kg/m3 of CCA and Fagus sylvatica with 6.1 kg/m3 of CCA. Both wood species were also treated with a copper plus triazole preservative (3 kg/m3 of copper) and chlorothalonil plus chlorpyriphos in oil (4.8 kg/m3 chlorothalonil). Furthermore, P. radiata was treated with ammoniacal copper plus a quaternary ammonium compound (2.6 kg/m3 copper) and a 60/40 ...
R N Wakeling
A biochemical explanation for the observed patterns of fungal decay in timber
1980 - IRG/WP 1111
Experiments designed to compare the degree of localization of the cellulase enzymes of some white, brown and soft rot organisms are described. The site and nature of binding of the enzymes is discussed. The technique is ellution of mycelium grown in liquid culture with a variety: of agents including acetate buffer, carboxymethyl cellulose solution, borate/glycerol buffer and urea. The mycelium was...
N B Green, D J Dickinson, J F Levy
The effect of aqueous leaching on moisture uptake by CCA-treated blocks during soil burial
1987 - IRG/WP 2283
Mass loss, moisture content and nitrogen data from two soil burial experiments with untreated and CCA-treated Scots pine (Pinus sylvestris L.), Sitka spruce (Picea sitchensis Carr) and lime (Tilia vulgaris Hayne) are presented. These show that aqueous leaching of CCA-treated wood prior to burial significantly reduces its subsequent moisture uptake from soil. In the case of lime, a reduction in the...
C A Green, G M Smith, B King
Hydrolysis of bordered pits during colonization of conifers by brown-rot fungi
1995 - IRG/WP 95-10103
Brown-rot decay results in rapid reduction in degree of polymerization (DP) of holocellulose with concomitant strength loss (MOR) without removing lignin. Development of new methods of wood protection will require focusing on early events in the sequence of depolymerization. Bordered pit membranes (sapwood) represent a readily available source of non-lignified carbohydrate, ie. pectin and cellulos...
F Green III, J L Tschernitz, T A Kuster, T L Highley
Fungal decay of acrylate treated wood
2004 - IRG/WP 04-30357
Natural durability of wood species is variable. Chemical wood preservatives, such as biocides are necessary for extension of their service life. Many methods have been developed to increase the resistance of wood and wood products against wood-destroying organisms during the last years. The most frequently used methods are chemical and thermal modification of wood. In wood modification the basic c...
Z Tiralova, L Reinprecht
Accidental mold/termite testing of high density fiberboard (HDF) treated with borates and N’N-naphthaloylhydroxylamine (NHA)
2003 - IRG/WP 03-10462
High density fibreboard (HDF) was made from beech and pine furnish (50:50) and treated with boric acid (0.1-3%), borax (0.1-3%) or N'-N-(1,8-naphthalyl) hydroxylamine (NHA) (0.1-1%) prior to gluing with urea formaldehyde (UF) resin in order to determine resistance to Eastern subterranean termites (Reticulitermes flavipes Kollar), the most economically important termite species in North Am...
S N Kartal, H H Burdsall Jr, F Green III
Immuno-scanning electron microscopic localization of extracellular polysaccharidases within the fibrillar sheath of the brown rot fungus Postia placenta
1991 - IRG/WP 1497
Extracellular polysaccharidases of the brown-rot fungus Postia placenta were localized using colloidal gold labeled monoclonal antibodies to the B-1,4-xylanase (32-36kDa) fraction of Postia placenta. Postia placenta was grown from agar onto glass coverslips, immunolabeled with or without prior fixation, and examined by SEM. Enzymes were localized on the hyphal surface and on the clumped fibrillar ...
F Green III, C A Clausen, M J Larsen, T L Highley
Distribution of boron from fused borate rods in Douglas-fir transmission poles
1996 - IRG/WP 96-30112
The diffusion of boron from fused borate rods (disodium octaborate tetrachydrate) was monitored over 42 months in CCA-treated Douglas-fir transmission poles. The boric acid equivalent was estimated by the curcumin/salicylic acid color test on increment cores removed from the poles. Moisture content of the poles was quite variable but was always above 20 percent. The percent of increment core lengt...
T L Highley, F Green III, W F Finney
The influence of fungal species and the level of decay on the mortality and feeding activity of adult Euophryum confine (Broun)
2002 - IRG/WP 02-10448
The mortality and feeding activity of adult Euophryum confine (Broun) (Coleoptera: Curculionidae) are used to establish the substrate conditions most suitable for their rearing. Weevils were allowed to feed on Pinus nigra (Arnold) sapwood blocks, either undecayed or
decayed to 10% weight loss ±5% by two brown rots Coniophora puteana (Schum.:Fr.) Karst. and Serpula lacrymans (Wulf.:Fr.) Schroeter...
M Green, A J Pitman
The development of a new boron-based wood preservative
1995 - IRG/WP 95-30085
The paper describes a new boron based wood preservative for the treatment of green timber. The product offers many benefits over conventional boron diffusion treatment including: 1. high viscosity, high concentration formulation; 2. permits dip treatment of a wide range of sawn board and pole sizes at ambient temperatures; 3. permits full cross section diffusion of borates without block stacking a...
P Turner, D Conradie
Fumigation of red beech in New Zealand for prevention of graystain
2000 - IRG/WP 00-10343
The discoloration of sapwood of red beech (Nothofagus fusca) after drying has been an ongoing problem which may lower value of material for certain applications (such as flooring) by as much as 50%. The dark gray stain noted after the drying and planing of lumber is not prevented by fungicide dips, and is most likely similar to the enzyme-mediated stain noted in a variety of commercial hardwoods. ...
E L Schmidt, B Kreber
Effect of fungal degradation on the chemical composition of acetylated beech wood
2003 - IRG/WP 03-40267
This study investigated the impact of fungal attack on the chemical composition of acetylated wood. Beech wood acetylated to different degrees was exposed to decay by the white-rot fungus Trametes versicolor under solid-state fermentation conditions. Laboratory soil-bed assays were also conducted to study the degradation of acetylated wood by soft rot fungi and other soil-inhabiting microorganisms...
H Militz, Dong-won Son, L Gómez-Hernández, R Sierra-Alvarez
Borate diffusion from fused borate rods in douglas-fir transmission poles
1994 - IRG/WP 94-30042
Pressure-treated utility poles have given many years of excellent service, but their lifetime is often shortened by internal decay of the untreated heartwood center, particularly in refractory species, such as Douglas-fir. This paper reports the distribution of boron from fused borate rods installed in CCA-treated Douglas-fir transmission poles. The boric acid equivalent was roughly monitored by t...
T L Highley, W Finney, F Green III
Hypoxylon species of the groups Papillata and Applanata on European beech in Serbia, Yugoslavia
1977 - IRG/WP 166
In the previous Document No: IRG/WP/165 under the title 'The most important characteristics of some species of the genus Hypoxylon found in Serbia, Yugoslavia', a contribution has been made regarding the importance of 4 species of this genus found in Serbia. In this paper the significance of the Hypoxylon species was emphasized in connection with their distribution and growth esp...
M Petrovic
The effects of accelerated drying of green Pinus radiata on its attractiveness to Anobium punctatum as an egg-laying site
1984 - IRG/WP 1199
The methods and results are given for a series of experiments in drying Pinus radiata sapwood under a variety of conditions, then exposing the material to Anobium punctatum egg-laying. The results showed very clearly that the attractiveness of the wood to gravid females was drastically reduced when dried from green at temperatures much above 35°C. Both simple oven drying and steam kilning produce...
D J Cross
Sawmill Evaluation of a Bioprotectant against Moulds, Stain and Decay on Green Lumber
2003 - IRG/WP 03-10460
Moulds, stain and decay cause serious problems on wood utilization. Though a growing volume of wood is kiln-dried, the market for green exports remains significant, and environment-friendly wood protection is required to replace traditional chemicals. As a solution to this problem, Forintek Canada Corp. developed a bioprotectant for protecting logs and green lumber from moulds, stain and decay, wh...
Dian-Qing Yang, M Gignac, M-C Bisson
The role of oxalic acid in short fiber formation by the brown-rot fungus Postia placenta
1993 - IRG/WP 93-10028
The mechanism by which brown-rot fungi depolymerize wood and cellulose remains a perplexing problem. Current evidence favors oxidation by low-molecular weight, non-enzymatic fungal metabolites. During attack of cotton cellulose by Postia placenta MAD-698, the degree of polymerization (DP) decreases to limit of degree of polymerization (LODP) over a period of 5-6 weeks with relatively low weight lo...
F Green III, J M Hackney, C A Clausen, M J Larsen, T L Highley
The role of oxalic acid in tolerance to N’N-naphthaloylhydroxylamine in Tyromyces palustris
2006 - IRG/WP 06-10584
Certain wood decay fungi exhibit tolerance to one or more wood preservatives. Copper tolerance of brown-rot fungi has been studied in our laboratory for the past six years. We have observed some degree of tolerance to N’N-naphthaloylhydroxamine (NHA), a recently patented termite bait, by the brown-rot fungus Tyromyces palustris TYP-6137. In an effort to try and confirm this tolerance in other is...
R A Arango, C A Clausen, F Green III
Efficacy of some fungicides against mold on freshly cut beech sawn wood
2006 - IRG/WP 06-30403
The quality class of molded wood is lowered and this can result in financial losses due a decrease in its trade value. Currently beech wood is often used without steaming it first and it moulds in the course of drying. The aim of this study was to identify kinetics of beech wood molding and effectiveness of action of chosen modern pro-ecological wood preservatives applied in the protection of fres...
A Fojutowski, A Kropacz
The effect of woody and non woody plants extractives on microbial resistance of non-durable species
2006 - IRG/WP 06-30392
The effect of Elm (Zelkova carpinifolia), Oak (Quercus castanifolia), Mulberry (Morus alba), Ash (Fraxinus excelsior) as woody plants, Rose (Rosa damascene) and Fumitory (Fumaria sp) as non woody plants extractives on durability of Beech (Fagus orientalis), Maple (Acer insgin), Alder (Alnus subcordata), and Lime (Tilia sp) were studied. First wood species having extractives were cut to small piece...
S M Kazemi, A Hosinzadeh, M B Rezaii
Influence of Acetylation on Fire Resistance of Beech Plywood
2006 - IRG/WP 06-40326
Influence of acetylation on fire resistance was studied in beech plywood. Beech layers were acetylated in a reactor with acetic anhydride at 120ºC for varying durations. Plywoods were made from the acetylated layers and directly exposed to burning flame from their edges for 60s according to ISO 11925-3. Ignition and glowing time were measured in samples. Results were analyzed statistically based ...
B Mohebby, A Talaii, A Karimi , S Kazemi Najafi