Your search resulted in 242 documents. Displaying 25 entries per page.
Impregnation of wood with antifungal compounds from low-quality tree biomass
2022 - IRG/WP 22-30763
In this paper we have reviewed recent research on the development of bio-based preservative formulations for wood done at the Department of wood science and technology, Ljubljana. Preservative formulations used in this investigation were prepared using plant polyphenols as biocidal agents. These nonstructural components of wood were stilbenes and flavonoids, and were extracted from wood of broken ...
V Vek, I Poljanšek, A Balzano, M Humar, P Oven
Utilization of Pressure Treated Lumber in Cross Laminated Timber Manufacture and its Impact on Bondline
2022 - IRG/WP 22-40953
Mass timber building construction is increasing dramatically across North America which presents challenges to these structures not seen in Northern Europe. Large parts of the United States harbor termites and existing mass timber building technologies that rely solely on moisture exclusion to increase durability are insufficient in these areas. The successful expansion of mass timber construction...
G Presley, C Wainscott, J Valenti, S Noble
Establishing the minimum effective penetration of wood preservatives in the refractory heartwood of E. nitens
2023 - IRG/WP 23-30780
Conventional pressure treatment of many Australian hardwoods results in little to no penetration of heartwood and a non-uniform envelope treatment of <5 mm surrounding a mostly untreated core. This is a major issue for many of the low durability plantation hardwood timbers that are grown in Tasmania, which contain high percentages of heartwood. Long term studies on softwoods such as spruce decking...
J R Vargas, J J Morrell, L Yermán, K C Wood
Identifying compatible waterborne timber preservatives and fire retardants for use in a VPI system: a practical approach
2023 - IRG/WP 23-30796
To enhance the use and suitability of timber in all applications in both exterior and interior settings, timber typically needs to be treated with a preservative and/or a fire retardant chemical. Combining fire retardants with preservatives into a single treatment process has been a long-term aim of researchers in the timber preservative industry because of the significant logistic and economic ad...
R Robinson, S Meldrum
Resistance of phenol formaldehyde impregnated beech (Fagus sylvativa L.) LVL against biodegradation in soil contact
2023 - IRG/WP 23-40965
Alternatives to preservative impregnation are emphasized in Germany and other European countries. Even though these treatments significantly improve wood's resistance to decay, they often do not have a beneficial impact on the dimensional stability. One alternative product, which may be used in ground contact for items like poles and railway sleepers, could be beech (Fagus sylvatica L.) laminated ...
M Slabohm, C Brischke, S Bicke, H Militz
Non-vacuum/pressure ACQ treatment
2023 - IRG/WP 23-40971
Many developing countries are located in sub-tropical or tropical regions where rapid wood deterioration results in early failure of many structures. Whilst preservative treatment would help to reduce these losses and extend the forest resource commercial vacuum pressure treatment systems are often too expensive. The use of lower technology treatment systems, while not as quick as vacuum pressure ...
J Norton
Through-boring to improve the performance of low durability Eucalyptus species for utility poles: 10-year field test results of pole stubs exposed in Southeast Queensland
2023 - IRG/WP 23-40972
An impending shortage of naturally durable hardwood electricity pole timbers in Australia has encouraged investigation of alternatives containing less durable, untreatable heartwood. Through-boring or drilling holes perpendicular to the long axis before treatment, has been used successfully on refractory softwood poles in North America and might have application in Australia. The use of through-bo...
J Norton, L P Francis, J J Morrell
Evaluation of the effectiveness of soaking of high-temperature plywood in low-temperature oil-based wood
2023 - IRG/WP 23-40991
We conducted a preliminary investigation to determine if soaking high-temperature plywood in a low-temperature preservative solution could achieve deeper penetration of the preservative, even in plywood made with refractory wood species such as Japanese larch. Specimens cut from commercial plywood (Japanese larch) were stored at various temperatures before being soaked in the preservative solution...
T Miyauchi, S Isaji, H Shibui, N Furuta, J Miyazaki, H Matusnaga
Elevated pressure hybrid wood modification: Synergistic effects on durability performance
2024 - IRG/WP 24-20725
The combination of different wood modification technologies to obtain improved performance is increasingly receiving attention in research. In this study, Scots Pine was impregnated with furfuryl alcohol (FFA) in pure aqueous 20, 40 and 60% solution strength without adding any catalyst. In a second step, the FFA was polymerized while simultaneously performing thermal modification in a closed syste...
P Klaas, D Jones
Service life of poplar, a low durability hardwood
2024 - IRG/WP 24-41007
Hybrid poplar is the most common plantation hardwood of the temperate climate zone and is complementary to natural stands of aspen with mainly plantations in Europe and China. Poplar wood has been considered as a valid alternative for many of the construction applications of softwoods especially when considering engineered wood products.
The natural durability of hybrid poplar is low and for a ra...
J Van Acker, X Jiang, L De Ligne, J van den Bulcke
Improvement and practical application of dry-type pressure treatment method
2025 - IRG/WP 25-20734
In years, the need for environmental consideration has been reaffirmed worldwide, and in Japan too, there is a demand for the expansion of the uses of wood in order to achieve a decarbonised society. So, there is also a need to develop and improve wood preservation treatment methods that overcome the weaknesses of wood and enable it to be used in a wide range of applications. The authors have impr...
D Tezuka, C Igarashi
Evaluation of 'Deep Penetration Treatment' for wood preservation
2025 - IRG/WP 25-20746
‘Deep Penetration Treatment’ (DPT) is a recently developed wood preservation technique in Japan designed to meet the preservation standards required for residential foundations. This method involves spraying a specially formulated solvent-borne wood preservative onto properly incised dried lumber. Despite being a non-pressure treatment, DPT achieves penetration levels comparable to conventiona...
M Ikeda, T Shigeyama, Y Sugai
The non-energy utilization of low-quality wood from the invasive species Prunus serotina
2025 - IRG/WP 25-30814
Alien invasive species in Europe, such as Prunus serotina, can significantly impact ecosystem structure and function. This species provides low-quality timber, which is most often used for energy purposes in the form of biomass. In the era of policies focused on a circular economy, seeking methods to extend the life cycle of raw materials and wood products is necessary. For this purpose, the wood ...
W Perdoch, P Kołwzan
Enhanced Termite Resistance of Low Durability Fast Growing Teak Wood by Non-Biocide Treatments Based on Chemical and Thermal Modification
2025 - IRG/WP 25-30818
Short rotation teak as a fast-growing tree can be considered as a renewable material resource for the future green economy. However, short rotation teak wood is susceptible to biodeterioration, particularly to termite attack. The objective of this work was to investigate the effect of chemical and thermal treatment on resistance of sapwood, transition wood, and heartwood of short rotation teak aga...
R Martha, K Candelier, M-F Thévenon, B George, I S Rahayu, W Darmawan, P Gérardin
Influence of plasma treatment on the coatability of wood primer with a topcoat for exterior use
2025 - IRG/WP 25-30828
The coatability of oil, or of solvent-borne alkyd resin wood primers with waterborne acrylic finish is the subject of much debate, but not much information can be found in the scientific literature on this topic. The aim of our study was therefore to evaluate the adhesion strength of the waterborne acrylic coating on oiled wood or wood with a solvent-based alkyd primer and to test the recoatabilit...
M Petrič, L Albreht, N B Štrus, E Keržič, M Pavlič, J Žigon, S Dahle
Validation of a measurement method for cyproconazole retention in pressure-treated wood through an interlaboratory study
2025 - IRG/WP 25-41037
The Japanese Agricultural standard (JAS) defines national regulations for preserved wood and wooden materials, in Japan. Traditionally the JAS focused on quality of product, however, the revision of the JAS Act in 2017 enabled standardisation of test or measurement method for the quality evaluation. The Japan Wood Protection Association (JWPA) has been working toward standardisation of methods for...
T Miyauchi, Y Itou, M Samejima
Investigation of Pressure-Treated Foundations with Wood Preservative and Termite Control in Existing Wooden Houses in Japan
2025 - IRG/WP 25-50402
Japan has extremely limited natural resources. Therefore, it is necessary to build a circular economy in which waste and other recyclable resources are effectively utilized in order to achieve sustainable development. This study aims to investigate the degradation of existing wooden houses and to contribute to the reuse of existing houses and the reuse of building materials during demolition. We i...
K Usami, T Kawada, H Ishiyama