Your search resulted in 294 documents. Displaying 25 entries per page.
Utilization of Pressure Treated Lumber in Cross Laminated Timber Manufacture and its Impact on Bondline
2022 - IRG/WP 22-40953
Mass timber building construction is increasing dramatically across North America which presents challenges to these structures not seen in Northern Europe. Large parts of the United States harbor termites and existing mass timber building technologies that rely solely on moisture exclusion to increase durability are insufficient in these areas. The successful expansion of mass timber construction...
G Presley, C Wainscott, J Valenti, S Noble
Improvement of durability of Scots pine against termites by impregnation with citric acid and glycerol followed by in situ polyesterification
2023 - IRG/WP 23-30777
Scots pine (Pinus sylvestris) sapwood samples were impregnated with solution containing citric acid (CA) and glycerol (Gly) followed by heating 140 °C according to already described procedure (L'hostis et al. 2018). The resulting modified woods were then used to evaluate the effect of chemical modification on the durability against termites. Two kinds of experiments were conducted for this purpos...
M Mubarok, J Damay, E Masson, E Fredon, Y S Hadi, I W Darmawan, P Gerardin
Tree bark as a renewable source of wood protection materials for building applications (BarkBuild)
2023 - IRG/WP 23-30792
The BarkBuild project aims to address climate change mitigation by developing new, sustainable, and long-lasting wood building materials with low environmental impact. The project focuses on developing bark-based wood protection and building formulations that demonstrate technical performance, safety, and sustainability in both outdoor and indoor applications. The research objectives of the projec...
A Treu, M Sipponen
Effect of impregnation modification treatment on properties of Paraserianthes falcataria wood
2023 - IRG/WP 23-40966
Modification treatment can improve the properties of wood, particularly those of fast-growing species. Paraserianthes falcataria, also known as batai, is a fast-growing species with low wood density. This species has piqued the interest of those involved in industrial wood processing as a promising alternative for construction. The aim of this study is to improve the dimensional stability of batai...
A S Yusoh, A S Boneka, M K Anwar U, S Salim, S H Lee
Modification of Gmelina arborea wood for utilization in Nigeria
2023 - IRG/WP 23-40986
The level of protection achieved by any wood treatment process is dependent on achieving a sufficient uptake and penetration of the treatment chemicals. This phenomenon is also applicable when considering chemical modification of any wood species. The desired changes in physical, mechanical or durability enhancement of treated species can only be achieved beyond a superficial treatment. For this, ...
S O Olaniran, H Militz
The potential of Wacapou (Vouacapoua americana) extracts to develop new biobased protective solutions for white woods
2024 - IRG/WP 24-20724
The valorisation of Amazonian wood residues into active chemical compounds could be an eco-friendly, cost effective and valuable way to develop wood preservatives formulations in order to enhance the decay and termite resistances of low durable wood species, by impregnation processes. Wacapou (Vouacapoua spp., Fabaceae) is a well-known Guianese wood species for its use in local wood construction ...
E Kieny, K Candelier, L Milhe, Y Estevez, C Sophie, R Lehnebach, J Damay, D Florez, E Hoël, M-F Thevenon, J Bossu
Elevated pressure hybrid wood modification: Synergistic effects on durability performance
2024 - IRG/WP 24-20725
The combination of different wood modification technologies to obtain improved performance is increasingly receiving attention in research. In this study, Scots Pine was impregnated with furfuryl alcohol (FFA) in pure aqueous 20, 40 and 60% solution strength without adding any catalyst. In a second step, the FFA was polymerized while simultaneously performing thermal modification in a closed syste...
P Klaas, D Jones
Physical, durability and chemical characterization of Gmelina arborea (Roxb.) wood treated with lactic acid
2024 - IRG/WP 24-30803
The increase in demand for durable wood has drawn attention to the use of fast-grown plantation species across the globe. Chemical modification was used to treat Gmelina arborea wood with lactic acid for property enhancement. The treated samples were obtained from two different ages of 15 and 10 years and sawn into (20 x 20 x 60) mm and (20 x 20 x 20) mm for physical, durability and chemical chara...
T O Akinwamide, J M Owoyemib, E A Iyiolac
Influence of the substitution of phenol with lignin cleavage products in phenol-formaldehyde impregnation resins for wood modification on the fungal decay resistance and impregnation depth
2024 - IRG/WP 24-30805
The impregnation modification of wood with phenol-formaldehyde (PF) resins increases the woods dimensional stability and resistance against fungal decay. However, to decrease the usage of non-renewable resources, the substitution of phenol has been a topic of scientific interest. Lignin is a currently underutilized resource with a chemical structure that contains phenolic units. For adhesive appli...
J Karthäuser, L Tarentino, A Treu, H Militz, G Alfredsen
Citric acid and sorbitol treatment: A comparative study of Canadian and Norwegian species
2024 - IRG/WP 24-30806
Dimensional instability can reduce the competitiveness of wood in exterior applications such as cladding and decking. The objective of this work was to evaluate the dimensional stability of permeable and refractory softwoods from Europe and North America modified via a sorbitol and citric acid treatment. White spruce and Norwegian spruce, refractory species, and jack pine and Scots pine, relativel...
D Schorr, Erik Larnøy, R Stirling, G Boivin
Evaluation of vacuum borate treated spruce or pine CLT in an above ground protected test in southern Mississippi
2024 - IRG/WP 24-41001
Cross laminated timber (CLT) has become a popular wood composite in large building applications that were previously limited to concrete and steel. To extend service and prevent biological attack, chemical protectants are often applied to wood. Cross laminated timber panels are not typically treated, in part due to a lack of data on efficient and effective methods for treating large panels. Ther...
M E Mankowski, A Taylor, G T Kirker
Improvement and practical application of dry-type pressure treatment method
2025 - IRG/WP 25-20734
In years, the need for environmental consideration has been reaffirmed worldwide, and in Japan too, there is a demand for the expansion of the uses of wood in order to achieve a decarbonised society. So, there is also a need to develop and improve wood preservation treatment methods that overcome the weaknesses of wood and enable it to be used in a wide range of applications. The authors have impr...
D Tezuka, C Igarashi
Transmission poles - Analysis of causes of premature failure in Slovenia
2025 - IRG/WP 25-20745
The study focuses on analysing the causes of the premature collapse of wooden transmission poles in Slovenia, where there have been several cases of rapid fungal decomposition of poles despite the planned lifespan of 30 to 50 years. The poles were made of Scots pine wood and impregnated with a copper-ethanolamine wood preservative. The research aimed to assess the condition of standing poles and e...
M Humar, B Lesar, N Kregar, S Drnovšek
Evaluation of 'Deep Penetration Treatment' for wood preservation
2025 - IRG/WP 25-20746
‘Deep Penetration Treatment’ (DPT) is a recently developed wood preservation technique in Japan designed to meet the preservation standards required for residential foundations. This method involves spraying a specially formulated solvent-borne wood preservative onto properly incised dried lumber. Despite being a non-pressure treatment, DPT achieves penetration levels comparable to conventiona...
M Ikeda, T Shigeyama, Y Sugai
The Impact of Drying Techniques on the Quality of Thermally Modified Wood
2025 - IRG/WP 25-30813
The wood drying technique applied before loading the dry wood into the ThermoWood® kiln may affect its properties. For this purpose, Scots pine (Pinus sylvestris) boards were first dried through three drying methods, including radio-frequency/vacuum (RF/V), mild, and moderate conventional drying, and then loaded into a ThermoWood® kiln for thermal modification at 212 °C for 3 hours according to...
M Ghorbanian Far, N Sharifi, A Nikoutadbir, A Tarmian, M Humar
Linking treatability with moisture dynamics
2025 - IRG/WP 25-41031
Wood preservation is inherently linked to the ability to penetrate treating liquids. The EN 147374 (2022) standard provides a methodology to assess treatability and allows to identify wood species in relation to treatability classes. Over the past decades, performance of wood species in applications in use class 3 has been linked both to the impact of moisture dynamics and the resistance against f...
J Van Acker, K De Vriendt, M Durimel, L De Ligne, J Van den Bulcke
Validation of a measurement method for cyproconazole retention in pressure-treated wood through an interlaboratory study
2025 - IRG/WP 25-41037
The Japanese Agricultural standard (JAS) defines national regulations for preserved wood and wooden materials, in Japan. Traditionally the JAS focused on quality of product, however, the revision of the JAS Act in 2017 enabled standardisation of test or measurement method for the quality evaluation. The Japan Wood Protection Association (JWPA) has been working toward standardisation of methods for...
T Miyauchi, Y Itou, M Samejima
Investigation of Impregnation Factors for Biomass-Based Phenol-Formaldehyde Resins
2025 - IRG/WP 25-41044
This study investigates the impregnation factors affecting the treatment of wood with biomass-based phenol-formaldehyde (PF) resins, such as impregnation methods, resin properties, and setting parameters like time and pressure. The goal is to ensure effective resin penetration into the wood cell wall structure, thereby enhancing wood durability and mechanical properties. Previous literature has la...
Y-C Huang, T-H Lin, P-Y Kuo
Investigation of Pressure-Treated Foundations with Wood Preservative and Termite Control in Existing Wooden Houses in Japan
2025 - IRG/WP 25-50402
Japan has extremely limited natural resources. Therefore, it is necessary to build a circular economy in which waste and other recyclable resources are effectively utilized in order to achieve sustainable development. This study aims to investigate the degradation of existing wooden houses and to contribute to the reuse of existing houses and the reuse of building materials during demolition. We i...
K Usami, T Kawada, H Ishiyama