Your search resulted in 841 documents. Displaying 25 entries per page.
Post-layup protection of mass timber elements in above ground protected exposures: 2-year results
2022 - IRG/WP 22-30766
Mass timber has seen increased use as a building material for low and mid-rise construction in recent decades. The durability of mass timber elements has not been fully examined and the effects of wood destroying organisms on this these materials merits attention. The effectiveness of currently labeled soil termiticides and passively applied biocides at post-construction or as remedial agents need...
M E Mankowski, T G Shelton, G T Kirker, J J Morrell
Above-Ground Termite Resistance of Naturally Durable Species in Ontario and Mississippi
2022 - IRG/WP 22-30767
A collaborative above-ground protected termite field test was initiated by FPInnovations and the USDA Forest Service at sites in Ontario and Mississippi. The aims of the experiment were to compare the rate of attack in protected, above-ground exposures by the subterranean termite species, Reticulitermes flavipes, between northern (Ontario) and southern (Mississippi) test sites and to generate perf...
R Stirling, M Mankowski
Durability against fungal decay of sorbitol and citric acid (SorCA) modified wood
2022 - IRG/WP 22-40928
Most European-grown wood species are susceptible to biological degradation, specifically, they suffer from a poor resistance against wood-destroying fungi. Therefore, prior to outdoor exposure, wood has to be treated either by applying a protective coating on its surface or by full-volume impregnation with antifungal chemicals. However, due to environmental and health concerns, the most frequently...
K Kurkowiak, L Emmerich, H Militz
Steam Pre-conditioning Treatment Prior to Acetylation: Impact on Dimensional Stability, Moisture Response Behaviour, and White-Rot Fungal Resistance of Hevea brasiliensis and Mitragyna ciliata Wood
2022 - IRG/WP 22-40930
The effect of steam pre-conditioning treatment on the dimensional stability, moisture response behaviour, and durability against white-rot fungus P. chrysosporium of acetylated Hevea brasiliensis and Mitragyna ciliata wood species were assessed. Defect-free specimens of both species from the top, middle, and base positions were selected, prepared according to ASTM D143-09 & ASTM D-2017 standards a...
E Uchechukwu Opara, J Mayowa Owoyemi, J Adeola Fuwape
Extraction of fungal colorants for their use in coloured coatings for wood
2022 - IRG/WP 22-40938
Microorganisms are highly interesting for the production of useful metabolites. Such metabolites are e.g. colorants, that can easily be produced on industrial scale and low material costs. To date some microbial produced colorants are used in textile- and food industry because of their low toxicity and sustainability compared to synthetically produced colorants. However, little is known about the ...
K Kusstatscher, N Pfabigan, M Senoner, L Orlowsky, A Steitz, B Forsthuber, S Niedermayer, R Gründlinger
The Resistance of Some Commercially Thermally Modified American Hardwoods to Termites and Fungi
2022 - IRG/WP 22-40944
Thermally Modified Wood (TMW) is now being produced in the United States but there are few data on the durability of these materials. In this study, commercially-produced thermally modified yellow poplar (Liriodendron tulipifera), red maple (Acer rubrum), and white ash (Fraxinus americana) were evaluated for fungal and termite resistance. The resistance of the three TMW species against Gloeophyllu...
B Cortes, B Bond, A Taylor, J Lloyd
Improving wood durability by mineralisation and thermal modification
2022 - IRG/WP 22-40948
A significant increase in the fungal durability of wood was achieved by using a modification procedure combining two environmentally friendly methods: thermal modification and mineralisation. It offers an ecological alternative to other biocidal treatments. European beech (Fagus sylvatica) and Norway spruce (Picea abies) were selected as model wood species and exposed to four different fungi: Gloe...
R Repič, A Pondelak, D Kržišnik, M Humar, A S Škapin
Phenol formaldehyde modification and termite resistance under laboratory testing
2022 - IRG/WP 22-40952
The development of phenol formaldehyde (PF) resins as a means of impregnating solid wood is one that has been explored for several decades, both in terms of conventional impregnation processing (Impreg) or compressional impregnation (Compreg). However, it is only recently with advances in processing conditions that the method truly affords a means of achieving conventional modification for solid t...
L Nunes, A Pitman, M Duarte, B Stefanowski, D Jones
Evaluation of Decay Resistance for the Larch Wood Heat-treated with Superheated Steam
2022 - IRG/WP 22-40956
Heat-treatment of wood is a process that involves applying heat ranging 160–260°C to improve its physico-mechanical properties and resistance against wood rot fungi. The level of the changes in the wood properties by heat-treatment differs depending on the temperature and duration of heat-treatment, as well as the types of heat transfer media used for heat-treatment. The heat-treatment on wood ...
Y Park, S-M Yoon, H Kim, W-J Hwang
Evaluation of different wood by-products for sustainable building biomaterial production using fungal mycelium
2022 - IRG/WP 22-50373
As human population increases, the demand for new innovative, sustainable, and low impact construction materials also grows. Mycelium-based composites have shown to be an excellent alternative for traditional products ranging from low-density objects to semi-structural applications. They also present the advantage of using the waste streams from other productive processes as feedstock, enabling th...
C Charpentier-Alfaro, M Poggerini, S Palanti, G Della Rocca, D Pellegrini, A Crisci
Characterization of the fungal communities associated with Aquilaria crassna Pierre ex Lecomte plantations in French Guiana
2023 - IRG/WP 23-11001
Aquilariais a tree species belonging to the family of the Thymeleaceae. When the tree is wounded, it can produce a blackened wood, also known as agarwood. The blackened wood has a darker colour than healthy wood and gives off a strong fragrance greatly appreciated by perfumers and by certain oriental religious communities. Production of this blackened wood is deemed to depend on environmental fact...
C Zaremski, C Malandain, O Sibourg, B Heuclin, N Amusant, M Ducousso, A Zaremski
Management of invasive West Indian drywood termite in Queensland: Transition from mandatory to voluntary treatment
2023 - IRG/WP 23-11002
Cryptotermes brevis, the West Indian drywood termite (WIDT) is the most destructive drywood termite globally. It is capable of infesting both softwoods and hardwoods in timber structures. In Australia C. brevis was first discovered in 1940s and later an established infestation was discovered in Maryborough, Queensland in 1966 and then in Brisbane and Bundaberg in 1975. In 1977 the Queensland Gover...
C Fitzgerald, B Hassan
Susceptibility of selected Australian commercial timbers to West Indian drywood termite Cryptotermes brevis
2023 - IRG/WP 23-11003
West Indian drywood termite (Cryptotermes brevis) is a globally distributed timber pest and is invasive in Queensland, Australia, causing widespread damage to structures and large economic impacts in control and repair costs. Despite this, the knowledge of which specific timbers are susceptible to attack is limited and requires investigation. Two six-week feeding trials were performed, exposing se...
W Haigh, R A Hayes, B Hassan
A novel method for assessing radial variation in termite resistance of timber
2023 - IRG/WP 23-11005
Australia has many timbers whose heartwood is highly resistant to fungal and termite attack; however, changing public policies have resulted in restricted access to many native forests where these species are found. Plantations of these same species are expected to replace these resources, but there are questions concerning whether timber from these trees will have the same resistance as the nati...
S Kleinschmidt, R McGavin
Subterranean termite control management in urban areas in Spain. Example of management in the old town of Vigo, Spain
2023 - IRG/WP 23-11006
Termites are wood destroying insects always present in the nature with an important wood decomposition function. In Europe, they are mainly located in the Mediterranean area. In Spain, termites are an important problem in urban areas. It is estimated about 80% of old historic towns in Spain are affected by subterranean termite attacks and it is the most important damage in wood structures and wood...
D Lorenzo, A Lozano, M Touza, J Benito
They might be boring: pests of timber-in-service deserve more attention
2023 - IRG/WP 23-11007
Insects affecting timber-in-service, particularly bostrichid borers and termites, are among the most frequently intercepted organisms at international and national borders, associated with wood packaging, wooden furniture and artefacts, and timber and timber products. There are more than 25 non-native insect species in the Bostrichidae, Ptinidae, Cerambycidae and Kalotermitidae, and at least 12 no...
H F Nahrung, F Tovar, A Carnegie
Assessment of the Material Durability and Structural Integrity of the Wooden Velodrome in Češča vas, Slovenia
2023 - IRG/WP 23-11012
Wood is a widely used material in the construction industry, and it has been utilized for thousands of years to create buildings and other structures. When wooden structures are designed, built, and maintained properly, they can be safe and long-lasting. Sports facilities, which provide athletes with a space to train, compete, and improve their abilities, are crucial in creating a strong and susta...
D Kržišnik, M Humar, B Lesar
Isolation of the microbiota from wood decay insects and some of their enzymatic activities
2023 - IRG/WP 23-11014
Wood decay organisms have the ability to degrade wood components (cellulose, hemicellulose and lignin) by enzymatic capacities, but these enzymes can belong to the proper organism, or to the associated microbiota. The identification of the microorganisms, as well as their role in the digestion of many substrates not always is very well known.
The wood decay insects produce big damages in wood str...
M T Troya, F Llinares, J Arranz, S Izpura-Luis, S M Santos, L Robertson
Metabolite analysis of fungal COS degradation and phylogenetic investigation of COSase genes
2023 - IRG/WP 23-11018
Fungi are the major species causing microbial deterioration that reduces the commercial value of wood, such as wood decay and surface contamination, so it is important to accumulate knowledge on the physiology of fungi in order to develop countermeasures against these problems. Most physiological studies of fungi that have been reported have concerned the metabolism of carbohydrates as a source of...
R Iizuka, S Hattori, I Ohtsu, D Hibbett, Y Katayama, M Yoshida
Japanese traditional wooden building construction project in Bangkok - Part 2 Verification of termite control method
2023 - IRG/WP 23-11022
We have confirmed the effectiveness in Thailand of chemicals and stainless steel mesh that have been proven effective in Japan.
Stake and container tests were conducted and the following results were obtained:
1. There is no damage on specimens covered with stainless steel mesh, CuAz-treated specimens both stake test and container test.
2. Natural pyrethrin-treated specimens without stainless ...
H Ishiyama, S Murakami
Comparison of culturable fungi found on two types of modified wood cladding
2023 - IRG/WP 23-11025
Modified woods are rapidly gaining popularity in the United States and are appearing on more public buildings. Because these are biocide-free products, they can support the growth of non-wood degrading fungi on their surfaces, many of which produce dark pigments and deface the cladding. Even growth of dark pigmented fungi on modified woods yields an even grey-black color, giving the materials a we...
G Presley, J Cappellazzi, B Held, R Blanchette
Field durability testing of wood above ground - Part 1: 15 years’ experience with the Bundle method
2023 - IRG/WP 23-20695
A ‘jack of all trades’ method for above-ground wood durability testing has been sought for decades, but until now no method has found its way into standardization. The method of choice shall be applicable for untreated and treated wood – ideally also for wood composites. It shall be reproducible, objective, fast, easy, and inexpensive. Finally, it shall provide high predictive power.
This s...
C Brischke, G Alfredsen, L Emmerich, M Humar, L Meyer-Veltrup
Field durability testing of wood above ground - Part 2: The full guideline of the Bundle method
2023 - IRG/WP 23-20696
To determine the biological durability of wood above ground, numerous approaches for test methods have been pursued and tried out in the field in the past. So far, no method has managed to find its way into a European standard. During the last 15 years, experience with the Bundle method has been gained. As described in Part 1 of this paper, the method is recommended as a suitable tool for determin...
C Brischke, G Alfredsen, L Emmerich, M Humar, L Meyer-Veltrup
Analytical retentions of active ingredients in H2F treated framing over a 12-year period
2023 - IRG/WP 23-20702
The H2F hazard class in Australia was developed to treat internal framing timber with a surface application of an insecticide, to control mainly termites. Two of the actives approved in AS 1604.1-2010 (and subsequent revisions) for this hazard class are bifenthrin and imidacloprid. The penetration zone of both actives is 0 – 2 mm from the wood surface.
Radiata pine sapwood framing timber wa...
A Siraa
Geopolymer as a fixation method for tannin-based wood preservatives
2023 - IRG/WP 23-30774
This study aims to test if a second step impregnation with a geopolymer solution can fix Colatan GT10, a commercial extract rich in tannins, to wood, reducing their leaching and improving their performance as wood preservatives. Scots pine sapwood specimens of 40×10×5 mm3 were impregnated with Colatan GT10 tannin mix, geopolymer, and as combined treatment Colatan GT10 with subsequent geopolymer ...
Y M López-Gómez, A Barbero-López, A Haapala