Your search resulted in 80 documents. Displaying 25 entries per page.
Methods for improving preservative penetration into wood: a review
2002 - IRG/WP 02-40227
Pressure treatment technologies have been available since the mid-1830's, but the processes used for wood treatment are still largely unable to overcome the fundamental limitations of flow through semi-permeable pit membranes. Instead, methods have arisen that attempt to improve treatability of the wood including incising, compression rolling, through boring, or radial drilling. Other a...
J J Morrell, P I Morris
Assessing health risks to occupants following remedial insecticidal treatment of timber in dwellings
1998 - IRG/WP 98-50101-27
Experiments have been carried out to assess (i) the aerial concentrations of volatile wood preservative constituents, and (ii) the potential for contamination from treated surfaces, following in situ insecticidal treatment of timbers in dwellings. Using white spirit as a model for volatile constituents in the treatment of free-standing, wood-lined chambers indicated that temperature and air exchan...
R J Orsler, E D Suttie, V Rijckaert
Co-operative tests concerning influence of solvent and drying method on the toxic limit of wood preservatives against Basidiomycetes. Preliminary report
1971 - IRG/WP 204
In the Working Group II of the Organization for Economic Co-operation and Development working group on wood preservation (now International Research Group on wood preservation) it was agreed that more knowledge was necessary concerning the influence of the solvent on the toxic limit of organic solvent types of wood preservatives against Basidiomycetes. A test program was drawn up and after discuss...
T Hof
Quantification des émanations de substances dans l'air ambiant a partir des bois traités
1993 - IRG/WP 93-50001-27
Pesticides on wood for the purpose of its protection may evaporate. Eventual toxicity of such emanations justifies risk assessment procedures for indoor air in building. This document describes bench scale tests based on the technique of chambers developped by CTBA/BIOTEC to determine the amount of pesticides and associated substances released to the ambient air. Results obtained with various pest...
H Sageot, M Lamour
Evaluation of fluid distribution in pressure treated wood in different flow directions
2004 - IRG/WP 04-40281
Among different methods, polymerization technique was chosen to study distribution of fluid through cell types in treated wood. Red maple wood specimens with the size of 2 by 2 by 4 cm (radial, tangential and longitudinal, respectively) were prepared. Styrene monomer was used as the fluid for impregnation; because its physical properties such as surface tension, specific gravity and viscosity fall...
A Omidvar, M H Schneider
The use of light organic solvents in industrial wood preservation - an environmental perspective
1995 - IRG/WP 95-50040-22
The paper examines the evolving regulatory environment concerning the use of hydrocarbon solvents in industry and, in particular, the European wood preserving sector. The implications of the proposed EU Directive on industrial solvent use are explained and possible responses to such regulation examined, including process modification, product changes and emission abatement, where necessary. The de...
G A Ewbank
Survey of conditioning treatment practices in the Philippines
1975 - IRG/WP 349
The wood preservation industry in the Philippines is at present beset by many problems. An association of the industry similar to those existing in other countries has only been initiated last year by FORPRIDECOM. It is hoped that the formal organisation of this association will bring into focus the importance of this particular industry in the economic and industrial development of the country. L...
R F Casin
Termite durability of sugi (Cryptomeria japonica) heartwood kiln-dried under high-temperature process in relation to wood extractives
2005 - IRG/WP 05-10547
Termite durability of sugi heartwood samples kiln-dried under a high-temperature process were evaluated by using Reticulitermes speratus (Kolbe) as a test termite sp. The n-hexane extractives of these samples were analysed by a GC technique. The less termite durability was shown on the wood samples dried under the high-temperature process, in comparison with that of the air-dried samples. No GC-p...
S Shibutani, E Obataya, K Hanata, S Doi
A new vacuum/pressure plant system
1988 - IRG/WP 3479
In the subtropical regions, the problem of wood supplying becomes more and more difficult to be solved. In that context, the Centre Technique Forestier Tropical had paid a particular attention to the valorization of products issued from plantations in dry zones of Africa. In these plantations, the products of clearings can be used as fencing, stakes or for traditional construction. However in thes...
C Dalois, R Schwartz, G R Y Déon
Co-operative tests concerning the influence of solvent and drying method on the toxic limit of wood preservatives against Coniophora cerebella
1972 - IRG/WP 216
In the working group II of the IRG it was agreed that more knowledge was necessary concerning the influence of the solvent on the toxic limit of organic solvent types of wood preservatives against Basidiomycetes. A test program was drawn up and after discussion in the mentioned working group the final program was accepted by the co-operating institutes in 1969. In the test program two fungicides, ...
T Hof
Pretreatment decay in poles of Pinus sylvestris
1987 - IRG/WP 1329
Storage damage by blue stain and decay in poles before impregnation has been increasingly observed during recent years and there have been reports that salt-impregnated poles today are of lower quality because of incipient decay being increasingly common. The attacks may have started at the time of cutting and then continued during the period of seasoning at the plant, which could be as long as tw...
H Lundström, M-L Edlund
Redistribution of boric acid in radiata pine during drying after preservative treatment
1993 - IRG/WP 93-40010
Samples of 100 x 50 mm² radiata pine were processed with a variety of options to produce dry, boron-treated wood. Concentrations of boric acid in the central one-ninth and in the whole of the wood cross-sections were determined by chemical analysis and compared. Diffusion treated material was dried by air, conventional kiln (70/60°C), or high temperature kiln (120/70°C). Four different predryin...
A J Bergervoet, D R Page, J A Drysdale
The control and pretreatment decay in air seasoning Scots and Corsican pine poles in England
1990 - IRG/WP 1451
Previous work clearly showed that air-seasoned, British grown Scots and Corsican pine poles are subject to serious pretreatment decay. In order to control these infections a range of pretreatments are currently being investigated. One series of treatments is designed not only to control decay but also allow the development of mould and stain fungi in order to achieve the desired increases in poros...
D J Dickinson, A R Zahora, A P Dodson
The effects of accelerated drying of green Pinus radiata on its attractiveness to Anobium punctatum as an egg-laying site
1984 - IRG/WP 1199
The methods and results are given for a series of experiments in drying Pinus radiata sapwood under a variety of conditions, then exposing the material to Anobium punctatum egg-laying. The results showed very clearly that the attractiveness of the wood to gravid females was drastically reduced when dried from green at temperatures much above 35°C. Both simple oven drying and steam kilning produce...
D J Cross
Radial flow of Bornmullerian fir (Abies bornmulleriana Mattf.) as affected by wood tapering and the condition of end wall structure of uniseriate ray parenchyma cells
2008 - IRG/WP 08-40441
Amenability to radial permeability of Bornmullerian fir (Abies bornmulleriana Mattf.) was studied on the base of the effects of wood tapering and the structure of end walls of uniseriate ray parenchyma cells. The results showed that the most remarkable culprits of the greatest fluid uptake (as the percentage of void volume filled by the fluid in the radial flow direction, RVVF%) are the lesser woo...
I Usta, S Aslan
Assessment of decay risk of airborne wood-decay fungi
2012 - IRG/WP 12-10787
The decay risk of airborne wood-decay fungi was investigated by using an air sampler. Japanese cedar disks measuring about 8 cm in diameter and 3 mm in thickness with moisture content at about 100 % were placed in a “BIOSAMP” air sampler and exposed to 1000 liters of air. Air sampling was carried out from June to September at the same sampling site in Tsukuba, Japan. The exposed disks were the...
I Momohara, Y Ota, K Sotome, T Nishimura
Differential response of wood to dry air thermal treatment (DATT) and soy oil thermal treatment (SOTT)
2009 - IRG/WP 09-40446
Thermal treatment is an alternative to chemical modification method which has been used to some extent in improving timber quality. In order to get the maximum benefits possible without compromising the various end-use quality requirements of timber, several possibilities have been and are still being investigated in relation to this technique. Clear wood samples (19 x 19 x 150mm) of kiln-dried re...
L Awoyemi
Barefoot-heat-impact of oil-heat-treated wood: An important thermal property of decking boards
2009 - IRG/WP 09-40458
In this study the phenomenon of sensual heat impression was examined, when walking with bare feet on sun exposed wood based decking boards. A suitable method for measuring the heat flux from decking boards into an artificial foot was developed. The method and measuring device is described as well as results from measuring three different decking board materials: Oil-heat-treated spruce (OHT), untr...
A O Rapp, C R Welzbacher, C Brischke
Ecological methods and products for wood protection used for restoration and conservation of built heritage cultural assets to increase natural durability and duration of exposure in open air museums
2010 - IRG/WP 10-40506
Wood is a perishable material, hygroscopic and fuel, which cause attention to selecting the wood species that is going to be exhibited in relation to humidity and soil. With variable depending on its humidity and moisture from the atmosphere or soil, wood is a good living environment for fungi and insects, but suffer biodegradation processes and dimensional changes. Observations over time on wood ...
M Pruna, D Purice, D Dumitru Copacean
Influence of Copper Preservative Type on Earlywood and Latewood Distribution of Copper in Treated Wood
2010 - IRG/WP 10-40507
Some of the new water based copper containing wood preservative systems use particulate “micronized” copper as the primary biocide instead of the more traditional soluble amine copper based systems. Studies were conducted to investigate how this difference in the type of copper system might impact both initial and post drying distribution of the preservatives in wood. Of specific interest wa...
A Zahora
A Review of Radial Flow of the Refractory Softwoods: An Example of Sitka Spruce
2011 - IRG/WP 11-40564
As one of the refractory softwood species, the major problems in the preservative treatment of spruce based on the radial flow relate to the anatomical structure of the wood material. The most important morphological features influencing this were the amount of the nature and the condition of both ray tracheids and ray parenchyma cells, and the cross-field pits in particular. The conducting pathwa...
Ilker Usta, Radovan Despot
Initial investigations into the spalting potential of Peruvian hardwoods
2014 - IRG/WP 14-10813
This study was performed to determine if several moderately-utilized Peruvian hardwoods had potential for spalting applications. We applied a modified decay jar methodology with six native Peruvian woods and three moulds, with a period of incubation of six weeks. Results showed that Nigrospora sphaerica and Marupa (Simarouba amara) resulted on the highest significant internal pigmentation (black),...
S M Vega Gutiérrez, S C Robinson
Encapsulation Systems Combined with DOT Borate Treatments – The Future of Treated Crossties
2014 - IRG/WP 14-40670
Borates have been utilized in wood protection systems for many decades but only recently have been used in North America to treat crossties. This colorless, ordorless and very effective wood protection chemical has the ability to arrest and prevent the colonization of wood by both basidiomycete decay fungi and insects such as beetles and termites while ties are air seasoning or in service. Since ...
S C Kitchens, T L Amburgey
Performance of kiln-dried and air-dried anti-sapstain treated pallet timber under use scenarios against wood discolouring fungi
2015 - IRG/WP 30669
During their lifespan there is a high probability that wooden pallets and packaging material will be exposed to rainfall or rewetting conditions, increasing the risk of growth of discolouring fungi. Kiln-drying of wooden pallets and packaging material without anti-sapstain treatment does not give efficient protection against wood discolouring fungi during rewetting periods. However additional temp...
A Steitz, E Stoyanova, N Pfabigan, R Gründlinger
Best handling practices for wood crossties (sleepers)
2015 - IRG/WP 15-40714
Wooden crossties (sleepers) dominate the rail industry in the USA. Most ties are hardwood treated with oil-borne preservatives using pressure treatment. Incipient decay (called ‘stack burn’) commonly develops during the pre-treatment drying process and reduces tie performance and longevity. Practices to minimize stack burn and enhance wooden tie performance are discussed as an aid to non-wood ...
N Irby, J Lloyd, A Taylor, J Watt