Your search resulted in 3108 documents. Displaying 25 entries per page.
Thermal modification of non-durable wood species 2. Improved wood properties of thermal treated wood
1998 - IRG/WP 98-40124
Properties of wood treated in a new heat-treatment process called the PLATO-process have been studied. Several wood species have been treated using this new thermal modification process using a range of process conditions (mainly time and temperature). In this study the characteristics of the treated wood were determined using samples from whole planks treated on pilot plant scale. The modified ch...
B F Tjeerdsma, M J Boonstra, H Militz
The treatability of five Indonesian wood species with BFCA preservative
1987 - IRG/WP 3428
This paper deals with a preliminary study on the treatability of five Indonesian wood species, i.e. Altingia excelsa (AE), Rhodoleria teysmanii (CA), Litsea odorivera (LO), Schima wallichii (SW) and Cratoxylon arborescens (CA). Wood samples measuring 4 x 4 x 100 cm³ were dipped into BFCA preservative solution for about 30 seconds. Preservative penetration and the surface area of treated zone were...
Nana Supriana, T K Waluyo
Marine wood-borer test with preservatives on the coasts of Turkey
1995 - IRG/WP 95-10091
Marine wood-borer tests were carried out on the coasts of Turkey (Marmara, Mediterranean Sea and Black Sea). Sapwood blocks of 8 x 15 x 30 cm³ in size from Scots pine, Bornmüller's fir oriental beech and sessile oak were used. The test blocks were treated with CCB-salts by full cell process and coal tar creosote by empty cell process. The test blocks were installed on exposure sites bef...
A Bobat
Termite resistance classification of some tropical and temperate species based on the laboratory choice test results against formosan termite, Coptotermes formosanu
2004 - IRG/WP 04-20291
The results of classification of termite durability were varied. We carried out
laboratory evaluation of the classification of termite durability on various species by
the choice test against formosan termite, Coptotermes formosanus. We classified five
grades (very sensitive to very resistant). According to our results, azobe, ipe, keruing,
intsia, kapur, yellow meranti, jarraah, malas, cypres...
K Suzuki
The accelerated L-joint test method for determination of the out of ground natural durability
1998 - IRG/WP 98-20146
The accelerated L-joint test incorporates a moistening device and uses a close end water trap in an open joint connection with a laminated tenon member consisting of the perishable reference wood species scots pine sapwood and beech.
After one year of exposure it is possible to show a distinct identification of natural durability classes 4 and 5 against the more durable wood species. Both weight ...
J Van Acker, C Brauwers, M Stevens
Effect of wood species on colonization by an unknown wood boring organisms in marine waters
1995 - IRG/WP 95-10108
The effect of wood species on the initial settlement by surface fouling organisms in marine environments was investigated by exposing heartwood panels of Douglas-fir ((Mirb.) Franco), western redcedar (Donn.), and Oregon white oak (Dougl. ex. Hooke) in an estuary located on the coast of Oregon. The oak and western redcedar panels were sparsely colonized over the first 39 days of exposure, while th...
K S Rao, P F Schnieder, J J Morrell
Review of current wood preservation in Turkey
2003 - IRG/WP 03-30315
The aim of this study was to find out the current potential of the Turkish wood preservation industry, and to make some suggestions for its further proceeding, because the forest products potential and the geographical location combined may give to the wood preservation industry in Turkey a great advantage for exportation treated wood materials to the Middle East Countries.
In this study, therefo...
I Usta
Durability of Wood/Plastic Composites Made From Parthenium species
2002 - IRG/WP 02-40225
Previous study indicated that the natural chemical constituents of the guayule plant (Parthenium argentatum) improved some durability properties of wood when it was treated with resin extracted from guayule. At present, there are about a dozen species of Parthenium growing in the North American continent. P. argentatum is the only species with harvestable amounts of the rubber latex. Other specie...
P Chow, F S Nakayama , J A Youngquist, J H Muehl, A M Krzysik
Possible durability transfer from durable to non durable wood species. The study case of teak wood
2001 - IRG/WP 01-10392
Teakwood is well known for its excellent natural durability, mostly due to its high proportion of extracts. Amongst these extracts, quinones, and more precisely some naphtoquinones (such as lapachol) and anthraquinones (such as tectoquinone) appear to play a crucial role in the resistance to wood decay organisms. At a laboratory scale, sawdust from malaysian teak heartwood has been extracted under...
M-F Thévenon, C Roussel, J-P Haluk
After 18 years, preservative dipping and brush treating continue to provide protection to shingles of western wood species
1997 - IRG/WP 97-30156
The presence of residual preservation in dip-treated and brush-treated shingles of various species from the western United States was assessed 18 years after installation using Aspergillus bioassays. The performance of western redcedar (Thuja plicata) was compared to western hemlock (Tsuga heterophylla), sugar pine (Pinus lambertiana) and western larch (Larix occidentalis). Untreated shingles of a...
T C Scheffer, D J Miller, J J Morrell
Evaluation of the permeability of fast grown wood species
1995 - IRG/WP 95-40042
The low natural durability of certain species of wood, implies the need for applying a protecting treatment to increase its life in service. Because of this, a knowledge of the permeability properties of the wood is desired. In this work, a simple and reliable method to evaluate the wood permeability is presented. For that, we have been used fast grown species, with low natural durability, Poplar ...
M T De Troya, A M Navarrete, E Sanchez, J E Garcia de los Rios, E L Rodríguez Trobajo
List of fungi in soft-rot tests
1975 - IRG/WP 105
This list gives information on the terrestrial and marine species and strains of fungi tested for soft-rot ability in pure culture with data on their decay activity in untreated wood. An index of the timber species tested is added. The compilation is based on 1) the list of soft-rot fungi of the former OECD Group (Doc.No. 27/DAS/CSI/M/559), Oct. 1968, prepared by R. Rösch and W. Liese, 2) informa...
G Seehann, W Liese, B Kess
Degradation of resin constituents in various wood species by the white rot fungus Bjerkandera sp. strain BOS55
1999 - IRG/WP 99-10301
In previous studies, the white-rot fungus Bjerkandera sp. strain BOS55 was shown to cause extensive degradation of lipophilic extractives (resin) in Scots pine wood. Further research was carried out in order to investigate the ability of Bjerkandera sp. for reducing resinous constituents in various softwood (Douglas fir, larch and spruce) and hardwood species (birch, beech and poplar). The greates...
J Dorado, T A Van Beek, F W Claassen, R Sierra-Alvarez
The influence of timber species and preservative treatment on spore germination of some wood-destroying Basidiomycetes
1988 - IRG/WP 2300
Basidiospores from six wood decay fungi exhibited varying germination rates on untreated softwood and hardwood blocks. Germination inhibition of all test fungi was recorded on pine sapwood. No preference for a certain timber species by a particular fungus was evident. Whereas almost complete inhibition of germination occurred on wood treated with a quarternary-ammonium based wood preservative, mos...
B M Hegarty, G Buchwald
Aggressiveness of Reticulitermes species in laboratory test
1993 - IRG/WP 93-10026
In European Standards concerned with the preventive action of wood preservatives against termites, i.e. EN 117, EN 118 the obligatory test species is Reticulitermes santonensis. It is argued that this species is more aggressive than the second European Reticulitermtes species, Reticulitermes lucifugus. Since Reticulitermes santonensis is confined to certain smaller areas in France and thus not rea...
H Hertel, S Pantos, D Rudolph
Variation in field test performance of untreated and CCA-treated lesser-known Surinamese wood species
2000 - IRG/WP 00-20213
In Suriname three different field test sites have been used to verify the biological durability of CCA-treated wood and a range of wood species including lesser-known and lesser-used wood species. In total 37 tropical wood species were tested untreated and for 17 of the less durable species CCA-treatments were included as well. Although the three sites are located in the tropical region they diffe...
J Van Acker, M Stevens, L Comvalius
Decay resistance of coconut and rubber woods. Alternative wood species from Ghana
2006 - IRG/WP 06-10596
With the expanding local and world wide demand for tropical timbers, there is increased interest in the suitability of lesser–used timber species as alternatives for the forest based industries in order to ensure sustainable forest management. In the forests of Ghana, there are quite a number of timber species that are lesser known and have not been adequately used due to the absence of informat...
S Amartey, M Humar, B Donkor, F Pohleven
Protection of a low-density mangrove timber species gewa (Excoecaria agallocha) through preparation of particleboard – An Assessment
2006 - IRG/WP 06-40348
It is now well established that the conversion of low-density and low-cost timbers into laminated, composite and densified form is an alternative of wood protection by means of wood preservatives. Once only the timber species gewa (Excoecaria agallocha) was used for manufacturing newsprint paper in Bangladesh, which is not continued today. The feasibility of commercial production of particleboard ...
A A Mahfuz, M O Hannan, M A Islam, M N Islam , M M Islam, A K Lahiry
Wood printing plates from the Dürer era – species identification and anatomical study
2007 - IRG/WP 07-20364
Anatomical examinations serve to answer questions regarding the artistic technique and authenticity of art objects made of wood. The wood of 28 printing plates from the 15th and 16th centuries from the Berlin Kupferstichkabinett were investigated. Seven of these which date from the Dürer era (Albrecht Dürer, 1471-1528) were examined in more detail. With one exception, the plates from the Dürer ...
M Penkuhn, W Unger
Difficulties applying Heat Treatment according to ISPM No. 15, when fast growth species are used
2007 - IRG/WP 07-40386
In 2002, the Interim Commission on Phytosanitary Measures (ICPM) adopted the International Standard for Phytosanitary Measures (ISPM) No. 15 (Guidelines for regulating wood packaging material in international trade). Two treatments are recognized: Heat Treatment (HT), in which wood must be heated to a core temperature of 56°C for 30 minutes, and fumigation with methyl bromide. As the last treatme...
O Encinas, J. I Briceño
Needs for wood durability research on planted tree species in the tropics
2008 - IRG/WP 08-10651
The area of forest plantation has been expanding especially in tropical Asia since 1990’s. Most of them are developed for pulp and paper industries and planted with fast growing trees. It is expected that wood from those fast growing trees are also used for value added products such as sawn timber. In order to promote the utilization of fast wood as the resource of value added products, natural...
K Yamamoto, T Toma, Ngo Duc Hiep, Nguyen Trong Nhan
Wood boring species present in the Tagus Estuary and the severity of their attack on wooden piles exposed in the area: a case study
2008 - IRG/WP 08-10664
Wood exposed in the marine environment is subject to degradation by wood boring organisms. This is probably one of the reasons why wood has been substituted by concrete and steel in maritime structures in many European coastal areas. Wooden piles obtained from a wharf exposed in the Tagus Estuary, Porto Brandão (Almada, Portugal) provided an opportunity to understand the main
agents of biodeter...
L M S Borges, L Nunes, A A Valente, P Palma
Natural durability of different wood species in above ground applications - Weight and MOE loss
2008 - IRG/WP 08-10667
In Norway, exterior wood structures have traditionally, nearly exclusively been made of untreated Norway spruce (Picea abies (L.) Karst) and pressure treated Scots pine (Pinus sylvestris L.). In recent years there has been a tendency that other wood species, like various Norwegian hardwoods or imported species, have been used in exterior above ground applications, often not surface treated. For se...
F G Evans, P-O Flæte, G Alfredsen
Molecular Methods: a Reliable Tool for the Identification of Wood Decay Fungi in Construction Timber
2008 - IRG/WP 08-20386
In the present study, we tested the practical value of several DNA-based methods to identify at the species level the most common wood-decaying fungi infecting buildings. We successfully extracted and amplified fungal DNA from pure cultures of twelve species of wood-inhabiting fungi, from oak and pine wood infected in laboratory with known strains, and from unknown field samples of wood collected ...
M Maître, M Kutnik, I Le Bayon, L Harvengt
Feasibility study on three furfurylated non-durable tropical wood species evaluated for resistance to brown, white and soft rot fungi
2008 - IRG/WP 08-40395
Furfurylation can protect non-durable wood species against biological degradation, but the method used today cannot fully protect the heartwood of Scots pine due to insufficient penetration. In order to test alternative wood substrates for furfurylation, three Malaysian grown wood species (Kelempayan, Rubberwood and Sena) were furfurylated and subjected to soil block decay testing. Their performan...
T Mark Venås, A H H Wong