Your search resulted in 27 documents. Displaying 25 entries per page.
Notes on a wood preservation industry in Medan, North Sumatera, Indonesia
1987 - IRG/WP 3405
This paper deals with a descriptive account on the development of a wood preservation industry in Medan, North Sumatera (Indonesia). The industry was established in 1974 when the State Owned Electicity Corporation decided to use wooden power poles for their distribution network in North Sumatera province. However, the use of wooden power poles was discontinued in 1981, so as the preservation indus...
N Supriana, A Murad
Studies on the destruction by marine borers of fishing boats along the north-eastern Black Sea coasts of Turkey
1980 - IRG/WP 451
Marine wood-boring organisms are attacking fishing boats along the northeastern coasts of the Black Sea, Turkey. The damage and the intensity of attack of Teredo navalis L in fishing boats were studied....
O A Sekendiz, R Ilhan
Fumigation as a remedial treatment: A review of North American literature
1983 - IRG/WP 3253
The development of the use of fumigants for eliminating decay in timber and roundwood in North America is reviewed. Initial experiments on oak wilt identified volatile chemicals which eradicated decay in roundwood. Subsequently, extensive experimentation on Douglas-fir poles in service showed that treatment with chloropicrin eliminated internal decay for more than ten years. Vorlex was also quite ...
J N R Ruddick
Development of decay in untreated, second-growth Douglas-Fir using two exposure techniques in North Queensland
1997 - IRG/WP 97-20110
The results of two exposure techniques for evaluating the development of wood decay in untreated, mill-run lumber from second-growth Douglas-fir containing both sapwood and heartwood are presented. Nominal 50 mm by 100 mm by 2.5 m (2 in. by 4 in. by 8 ft) lumber, No 2 and better, was obtained from a production run in a mill that was processing second growth, Coastal Douglas-fir in western Oregon, ...
J Norton, S Kleinschmidt, R C De Groot, D Crawford
Review of Mold Issues in North America and Mold Research at Forintek
2003 - IRG/WP 03-10458
Over the last decade, air quality in homes and workplaces has become a high profile issue especially in relation to mold, receiving considerable media, public and legal attention. Forintek Canada Corp. and the wood industry in general have experienced large increases in inquiries regarding mold and the suitability of wood as substrate for its growth. Because wet wood supports growth of fungi the ...
A Uzunovic, A Byrne, Dian-Qing Yang, P I Morris
A comparison between the effects of ACC & CFK on the durability of beech, hornbeam and cottonwood by using Dipping & Bethel methods in the North of Iran
1997 - IRG/WP 97-40089
From the economical point of view, increasing the lumber durability by the application of preservative treatments is very important. In this study, samples were randomly selected from Fagus orientalis Lipsky., Carpinus betulus L. and Populus deltoides Bartr. in two forms (Board & Squared cross-section) and have been treated with ACC & CFK by using Dipping & Bethel methods. The matched ...
D Parsapajouh, V Etemad, K Pourtahmasebi
Introduction of plank-built catamarans along the north coast of Andhra Pradesh, India – A development of recent origin
2003 - IRG/WP 03-10483
Hitherto, the most versatile fishing craft of the poor traditional Indian fishermen - the catamaran is made of solid timber logs of a few selected species of broad-leaved softwoods. Of late, the fishermen find it difficult to get these conventional varieties of timber chiefly because of three reasons, a) scarcity of commodity, b) prohibitive costs and c) competition from match and veneer industri...
M V Rao, K S Rao, M Balaji, V Kuppusamy
Accelerated laboratory testing of preservatives on 13 North American wood species
1999 - IRG/WP 99-30201
The ability of selected water and solvent based biocides to protect wood against fungal attack was evaluated on 13 North American wood species using 7 decay fungi in a modified soil block test. Most preservatives were capable of providing protection at their recommended above ground and soil contact use levels. Many decay fungi caused substantial weight losses on blocks treated with chlorothalonil...
J J Morrell, C M Freitag
The field performance of CCA-C treated sawn refractory softwoods from North America
1997 - IRG/WP 97-40085
Approximately 15% of the total volume of wood treated in the United States consists of difficult to treat softwoods known as "refractory softwoods". The long term positive performance record of CCA treated sawn material is based upon the testing of yellow pine sapwood stakes with only limited field data available for sawn refractory softwoods. As a result, the existing North American wood preserva...
M J Richards, W S McNamara
Oxine copper (NYTEK® GD) for the control of mould and sapstain on lumber in North America
1989 - IRG/WP 3517
NYTEK® GD is a new, water-based, micro-dispersible formulation of oxine copper registered in the United States and Canada for control of mold and sapstain-causing fungi. NYTEK GD is noncorrosive and of low hazard to applicators and people handling treated lumber, when used according to the label. The product is an effective wood protectant applied as a dip or spray treatment at concentrations of ...
D F Myers, J M Fyler, C H Palmer, G D Rosebery
Susceptibility of CCA treated North American hardwoods to Chaetomium globosum decay
1998 - IRG/WP 98-10278
Seven species of hardwood, Beech (Fagus grandifolia), Basswood (Tilia americana), Maple (Acer rubrum), Oak (Quercus rubra), Trembling Aspen (Populus tremuloides), White birch (Betula papyrifera) and Yellow poplar (Liriodendron tulipifera) were vacuum or pressure impregnated with CCA, at four retention levels. The CCA was allowed to fix in the wood at 35°C. Red pine (Pinus resinosa) was also inclu...
U Srinivasan, Y T Ung, P A Cooper
Utilization of coconut timber from north Sulawesi, Indonesia. Part 1: Durability
1994 - IRG/WP 94-30044
Coconut timber from non-productive plantations is a byproduct of an agricultural crop and, by the same token, constitutes a renewable resource which may serve as a complement to or, at least in part, as a substitute for traditional timbers in local markets. Its more extensive utilization is expected to contribute to the conservation of tropical rain forests. Export of coconut timber and/or wood pr...
R-D Peek
Recent development in North American industrial wood preservation plants
1988 - IRG/WP 3467
After remaining static for many years there have been a number of changes in plant design and treating cycles in recent years. This has been particularly true in the USA where few restrictions are placed on plant treating cycles by specifications; since only results type specifications are used. It is also important to realize that the AWPA Specifications for Southern Yellow Pine only call for tre...
J F Bridges
Utilization of coconut timber from north Sulawesi, Indonesia. Part 2: Treatability
1994 - IRG/WP 94-40025
Under tropical conditions coconut wood is quickly degraded by mold and blue stain fungi. Low density wood in ground contact is commonly decomposed by wood destroying fungi within a period of only a few months, higher density wood from the outer stem regions within 24 to 30 months (MOSTEIRO, CASIN, SERIBAN 1976; McQUIRE 1975). Moreover, according to McQUIRE (1975) green wood of lower density is hig...
R-D Peek
The performance in the sea of seven experimental piles after sixteen years at Port Douglas, North Queensland
1989 - IRG/WP 4151
After 16 years at Port Douglas, two double-treated Pinus radiata piles were in excellent condition, a CCA-treated Pinus elliottii pile was in good condition other than for a confined streak of teredinid attack, while two CCA-treated and two untreated turpentine piles were moderately to severely attacked by Sphaeroma in the tidal zone. The marine borers collected were Sphaeroma terebrans, Martesia ...
L J Cookson, J E Barnacle, C N McEvoy
Chromated copper arsenate preservative treatment of hardwoods. Part 2: leaching performance of seven North American hardwoods
1997 - IRG/WP 97-30132
Seven North American hardwood species were treated with 2% CCA-C solution and fixed at temperatures of 21°C and 50°C and conditions of high relative humidity (95%) as described in Part 1 of this presentation. Red pine (Pinus resinosa) was included as a softwood for comparison. Adequately fixed wood blocks (99.9% chromium fixation) were exposed to leaching tests according to AWPA E11-87 test. Par...
T Stevanovic-Janezic, P A Cooper, Y T Ung
Chromated copper arsenate preservative treatment of hardwoods. Part 1: CCA fixation performance of seven North american hardwoods
1997 - IRG/WP 97-30131
There has been an increased interest in utilisation of hardwoods from eastern North America for exterior applications which require protection with preservatives such as CCA. We have examined CCA fixation at two selected temperatures of seven common North American species: red maple (Acer rubrum L.,), white birch (Betula papyrifera ), yellow poplar (Liriodendron tulipifera L.), trembling aspen (Po...
T Stevanovic-Janezic, P A Cooper, Y T Ung
Survey of North American practice in conditioning forest products before preservative treatment
1972 - IRG/WP 308
Seasoning requirements for the wide range of forest products which are treated with preservatives and fire retardants must be capable of dealing with a very complex set of conditions which are summarized under a number of variables including type and hazard of end use, the most effective distribution of preservative, a wide range of cross sectional dimensions, the possibility of seasoning by a ran...
J Rak, T S McKnight
A New Decay Hazard Map for North America Using the Scheffer Index
2008 - IRG/WP 08-10672
Wood decay experts in the USA and Canada use the Scheffer Index for above-ground wood decay potential to decide among design and treatment options to ensure the durability of wood construction. This paper provides an updated North American decay hazard map and includes data on Central America. Index values calculated from recent climate data are higher than published values due to directional or c...
P I Morris, J Wang
Field Tests of naturally Durable North American Wood Species
2008 - IRG/WP 08-10675
There has been little field test performance data published on North American naturally durable species in general, and no published data on second growth material in particular. Yellow cedar (Callitropsis nootkatensis), western red cedar (Thuja plicata), eastern white cedar (Thuja occidentalis), and three wood species reputed to be moderately durable were installed in ground-contact (stakes) an...
P E Laks, P I Morris, G M Larkin, J K Ingram
The case for using borates in termite control in tropical Australia
2011 - IRG/WP 11-30573
A brief historical overview of boron based wood preservatives efficacy against subterranean termite management worldwide, and in Australia, is presented. The boron based compounds to be used in H2 hazard conditions, may be applied as a surface treatment by dip, flood coat or spray, and rapidly penetrates to the centre of timber substrates, whether containing sapwood or heartwood. However, section ...
B M Ahmed (Shiday), J R J French
Extractives in Norwegian-Grown and North American-Grown Western Redcedar and Their Relation to Durability
2012 - IRG/WP 12-10762
The extractives responsible for the natural durability of western redcedar (WRC) are not well understood. Recent work by the Norwegian Institute of Wood Technology and the Norwegian Forest and Landscape Institute has evaluated the natural durability of Norwegian wood species and reference species, including Norwegian-grown WRC and North American-grown WRC, in a series of decay tests. The availabil...
R Stirling, P O Flæte, G Alfredsen, P I Morris
The importance of proper taxonomic identification, a case study with Reticulitermes spp. from USA
2012 - IRG/WP 12-10774
Taxonomy has been evolving with recent advancement in molecular and internet technologies. The importance of a stable taxonomic foundation is unquestionable as this science provides crucial information about evolutionary relationships and allows questions about the life history and ecology of organisms to be asked. We hope to highlight the issues and lessons we have learned from revising the taxon...
Su Yee Lim, B T Forschler
Performance of Norway spruce bridge in North-West Spain after 12 years exposure
2017 - IRG/WP 17-40796
Across Europe is very common to find bridges build in sawn and glue-laminated wood. Most of these bridges used softwood wood species such as: fir, spruce, larch and pine.
In Spain wooden bridges, became more and more popular since nineties, when sawn and glue-laminated wood were utilized for building exterior wooden structures in overall Spain.
This material, sawn and glue-laminated wood, are ma...
D Lorenzo, J Fernández-Golfín, M Touza, M Guaita, A Lozano, J Benito
Occurrence of synanthropic beetles (Coleoptera Ptinidae) and checkered beetles (Coleoptera Cleridae) in relation to climatic factors in historical buildings from North-Eastern Germany
2021 - IRG/WP 21-10980
Predatory checkered beetles occur in many historical buildings. Thus, it is essential to learn more about the ecology of these beetles, specifically for their further use as suitable beneficial organisms in biological control of wood-destroying insects. In this study, indoor climatic conditions were examined as a major factor influencing their occurrence and that of their prey Anobium punctatum an...
C Baar, C von Laar, M Willert, H Bombeck