Your search resulted in 400 documents. Displaying 25 entries per page.
Visual assessment of longitudinal wheel timbers and assessing the feasibility of extending wheel timber service life in the UK railway network
2019 - IRG/WP 19-20651
Timber has been a versatile building material for centuries and during the start of the Railway Age in the nineteenth century it was in considerable demand for use in the railway network, particularly bridge building. Timber is still in service and widely used throughout the UK railway network. The resilience and favourable strength to weight ratio and its relative ease of fabrication make it an...
J R Williams
Protecting Sustainable Wood Infrastructure ̶ Improving the Performance of Poles, Piles, Ties & Timbers with Dual Treatments
2019 - IRG/WP 19-30735
Wood is by far the best structural material in terms of environmental impact, as shown by a number of LCA studies. This environmental impact superiority can be improved if the longevity of the commodity is extended. The main durability concern in large cross-section treated materials is the susceptibility of the heartwood to decay, as it is not typically treatable using traditional methods. This ...
J Lloyd, A Taylor, C Brischke, N Irby, M Manning
Treatability of native and exotic alternative timber species
2019 - IRG/WP 19-40864
The service life of moderately durable species can be extended significantly if the challenge of effective treatment of refractory wood species can be overcome. Along with preservative effectiveness, the performance of preservative in treated wood depends on factors such as retention and penetration in treated wood, the wood anatomy, the uniformity of penetration and micro-distribution within the ...
D Page, T Singh
Promoting Commercially Available Epoxy Resins for Non-biocidal Wood Preservation
2019 - IRG/WP 19-40877
Commercially available epoxy and polyamine resins were evaluated with the aim of developing new non-biocidal wood preservation treatments. A simple method allowing the impregnation of wood by vacuum double impregnation followed by a curing process was developed for two reference species, beech Fagus sylvatica and Scots pine Pinus sylvestris. The tested products were evaluated for their ability to ...
P Poveda, M Mubarok, S Dumarcay, M Montibus, I Le Bayon, M Kutnik, P Gerardin, F Simon
Alternative products enhancing dimensional stability comparing to conventional treated products in Japan
2019 - IRG/WP 19-40885
The Act on the Promotion of the Utilization of Wood in Public Buildings (2010) in Japan has made a new stream of the utilization field of timber from housing constructions to larger scale non-housing constructions. After the act, the performance of dimensional stability in preservative treated products becomes more important factor than before. Therefore, various technologies have been developed, ...
K Yamamoto, D Tezuka, Y Sugai, S Maeda, I Momohara
Studying amount, location and state of water in modified wood at moisture levels relevant for fungal degradation
2020 - IRG/WP 20-40889
Water is an essential parameter for fungal degradation of wood, but degradation primarily occurs at high moisture levels at water potential in the range of -4 to -0.1 MPa, which corresponds to 97-99.9% relative humidity. At these moisture levels, water is present in the wood structure both in and outside of cell walls. The majority of previous studies on the interaction between wood and water for ...
M Fredriksson, E Engelund Thybring, Ramunas Digaitis
Longterm Performance of Treated Timbers in Marine Exposures
2020 - IRG/WP 20-10969
The performance of preservative-treated or modified woods in marine exposures was evaluated at test sites in Newport, Oregon, USA and Brisbane, Queensland, Australia. All samples have exhibited excellent performance at the Newport, Oregon site, while attack was more aggressive at the sub-tropical Brisbane site. Acetylated wood as well as samples treated with 7.3% chromated copper arsenate (CCA-T...
M Konkler, A R Zahora, J Norton, J J Morrell
Development of procedures for sampling, testing, and classification to determine the biological durability of wood and wood products
2020 - IRG/WP 20-20676
This paper informs about a research project, which deals with several shortcomings and a lack of clarity within EN 350:2016. The project started in January 2020, will run for 3 years, and is operated by the Institute of Wood Technology Dresden (IHD) and the University of Goettingen (UGOE).
Determination and classification of durability of wood and wood products against wood-destroying organisms ...
W Scheiding, K Jacobs, S Bollmus, C Brischke
Sterilization of Large Timbers during Preservative Treatment: How Quickly We Forget
2020 - IRG/WP 20-40902
Air seasoning is a common method of moisture management in utility poles and is done de facto during pole storage prior to treatment. However, extended air drying prior to treatment encourages fungal attack and can facilitate establishment of decay fungi in poles before a protective preservative barrier is applied. This problem can be mitigated by proper air-seasoning methods coupled with heat ste...
G Presley, J Cappellazzi, M Konkler, K Maguire, R Nelson, J J Morrell
Mechanical and biological durability properties against soft-rot and subterranean termite in the field (grave-yard test) of beech wood impregnated with different derivatives of glycerol or polyglycerol and maleic anhydride followed by thermal modification in an opened or in a closed system
2021 - IRG/WP 21-40917
This paper presents mechanical and biological durability properties in soil beg test (soft-rot test) and field test (grave-yard test) against subterranean termite of the wood modified with an aqueous vinylic derivative of glycerol/polyglycerol or maleic anhydride cured in an opened or in a closed system. Wood modification was performed through impregnation of European beech (Fagus sylvatica) with ...
M Mubarok, H Militz, S Dumarcay, I W Darmawan, Y S Hadi, P Gerardin
Preliminary investigation for preservation method of CLT using non-pressure treatment
2021 - IRG/WP 21-40919
Cross-laminated Timber (CLT) is increasingly being used in residential and non-residential construction around the world, and some of these areas are at high risk of biodeterioration. Addition to moisture management of construction, preservative treatment of CLT may be needed to prevent decay and termite attack in the area. Pressure treatment being most reliable, is not feasible due to the large d...
T Miyauchi, Y Ohashi, J Miyazaki, R Takanashi, H Shibui, S Isaji, T Shigeyama, Y Sugai, A Yamamoto, T Hramiishi, T Mori, H Matsunaga
Utilization of Pressure Treated Lumber in Cross Laminated Timber Manufacture and its Impact on Bondline
2022 - IRG/WP 22-40953
Mass timber building construction is increasing dramatically across North America which presents challenges to these structures not seen in Northern Europe. Large parts of the United States harbor termites and existing mass timber building technologies that rely solely on moisture exclusion to increase durability are insufficient in these areas. The successful expansion of mass timber construction...
G Presley, C Wainscott, J Valenti, S Noble
Susceptibility of selected Australian commercial timbers to West Indian drywood termite Cryptotermes brevis
2023 - IRG/WP 23-11003
West Indian drywood termite (Cryptotermes brevis) is a globally distributed timber pest and is invasive in Queensland, Australia, causing widespread damage to structures and large economic impacts in control and repair costs. Despite this, the knowledge of which specific timbers are susceptible to attack is limited and requires investigation. Two six-week feeding trials were performed, exposing se...
W Haigh, R A Hayes, B Hassan
Long-term Performance of Treated Timbers in a Sub-tropical Marine Exposure
2023 - IRG/WP 23-11015
The long-term performance of preservative-treated and modified wood in marine exposures was assessed in Brisbane, Queensland, Australia. This report describes the final destructive assessment of the surviving Australian panels after 11 years of exposure. This site presents the potential for attack by shipworms (likely Bankia spp.), pholads (Martesia striata), Limnoria and Sphaeroma terebrans. Mos...
E L Galore, J Norton, A Zahora
Identifying compatible waterborne timber preservatives and fire retardants for use in a VPI system: a practical approach
2023 - IRG/WP 23-30796
To enhance the use and suitability of timber in all applications in both exterior and interior settings, timber typically needs to be treated with a preservative and/or a fire retardant chemical. Combining fire retardants with preservatives into a single treatment process has been a long-term aim of researchers in the timber preservative industry because of the significant logistic and economic ad...
R Robinson, S Meldrum
Resistance of phenol formaldehyde impregnated beech (Fagus sylvativa L.) LVL against biodegradation in soil contact
2023 - IRG/WP 23-40965
Alternatives to preservative impregnation are emphasized in Germany and other European countries. Even though these treatments significantly improve wood's resistance to decay, they often do not have a beneficial impact on the dimensional stability. One alternative product, which may be used in ground contact for items like poles and railway sleepers, could be beech (Fagus sylvatica L.) laminated ...
M Slabohm, C Brischke, S Bicke, H Militz
Longitudinal tensile shear properties of polyurethane-bonded preservative-impregnated Eucalyptus grandis laminates subjected to varied simulated climatic conditions
2023 - IRG/WP 23-40967
Bonding process adaptations have yielded improvements in the adhesive bonding of Eucalyptus grandis wood for manufacturing hardwood laminates. However, there are still concerns over the adhesive-bond performance, particularly preservative-impregnated E. grandis laminates, under exposure to varying climatic conditions. These concerns could limit the implementation of E. grandis laminates, especiall...
A A Alade, C B Wessels
Non-vacuum/pressure ACQ treatment
2023 - IRG/WP 23-40971
Many developing countries are located in sub-tropical or tropical regions where rapid wood deterioration results in early failure of many structures. Whilst preservative treatment would help to reduce these losses and extend the forest resource commercial vacuum pressure treatment systems are often too expensive. The use of lower technology treatment systems, while not as quick as vacuum pressure ...
J Norton
Elevated pressure hybrid wood modification: Synergistic effects on durability performance
2024 - IRG/WP 24-20725
The combination of different wood modification technologies to obtain improved performance is increasingly receiving attention in research. In this study, Scots Pine was impregnated with furfuryl alcohol (FFA) in pure aqueous 20, 40 and 60% solution strength without adding any catalyst. In a second step, the FFA was polymerized while simultaneously performing thermal modification in a closed syste...
P Klaas, D Jones
Improvement and practical application of dry-type pressure treatment method
2025 - IRG/WP 25-20734
In years, the need for environmental consideration has been reaffirmed worldwide, and in Japan too, there is a demand for the expansion of the uses of wood in order to achieve a decarbonised society. So, there is also a need to develop and improve wood preservation treatment methods that overcome the weaknesses of wood and enable it to be used in a wide range of applications. The authors have impr...
D Tezuka, C Igarashi
Evaluation of 'Deep Penetration Treatment' for wood preservation
2025 - IRG/WP 25-20746
‘Deep Penetration Treatment’ (DPT) is a recently developed wood preservation technique in Japan designed to meet the preservation standards required for residential foundations. This method involves spraying a specially formulated solvent-borne wood preservative onto properly incised dried lumber. Despite being a non-pressure treatment, DPT achieves penetration levels comparable to conventiona...
M Ikeda, T Shigeyama, Y Sugai
Biocomposites based on fungal mycelium and beech particles impregnated with BPCM (bio-phase change material) for thermal energy storage
2025 - IRG/WP 25-41034
The building sector is a major contributor to Europe's carbon emissions, and transition to a bio-based economy is essential for achieving long-term sustainability goals. The European Union has set ambitious targets for climate-neutral heating and cooling by 2050, which requires the widespread adoption of energy-efficient and environmentally friendly technologies. A key element in this transition i...
E Nigrone, F De Francesco, J Conti, M Jebrane, M Nazari, N Terziev, S Palanti
Validation of a measurement method for cyproconazole retention in pressure-treated wood through an interlaboratory study
2025 - IRG/WP 25-41037
The Japanese Agricultural standard (JAS) defines national regulations for preserved wood and wooden materials, in Japan. Traditionally the JAS focused on quality of product, however, the revision of the JAS Act in 2017 enabled standardisation of test or measurement method for the quality evaluation. The Japan Wood Protection Association (JWPA) has been working toward standardisation of methods for...
T Miyauchi, Y Itou, M Samejima
Towards Sustainable Wood Protection: PF resins-impregnated Paper Honeycombs and the role of Processing Parameters analysis by Response Surface Methodology
2025 - IRG/WP 25-41045
Honeycomb paperboard is an important wood-derived product and also an emerging new material to combine with wood panels. It is commonly applied as cushioning materials with excellent mechanical performance, and high demands in packaging market. The aims of this study were to enhance the durability of honeycomb paperboard using PF resins of various molecular weights (Mw 200, Mw 500, Mw 700), partic...
Y-C Wu, P-Y Kuo
Investigation of Pressure-Treated Foundations with Wood Preservative and Termite Control in Existing Wooden Houses in Japan
2025 - IRG/WP 25-50402
Japan has extremely limited natural resources. Therefore, it is necessary to build a circular economy in which waste and other recyclable resources are effectively utilized in order to achieve sustainable development. This study aims to investigate the degradation of existing wooden houses and to contribute to the reuse of existing houses and the reuse of building materials during demolition. We i...
K Usami, T Kawada, H Ishiyama