Your search resulted in 3539 documents. Displaying 25 entries per page.
Evaluation of the water exclusion ability and inherent bioactivity of heartwood against decay in Japanese and European wood species via above-ground exposure and water absorption tests
2024 - IRG/WP 24-40998
The natural durability of wood has been thought to mainly depend on bioactive extractives and the water exclusion ability. To clarify the contribution of each factor to wood durability, above-ground exposure tests were conducted on Japanese and European wood species. A double-layer test was carried out using heartwood specimens of four wood species, i.e., Japanese cedar, Japanese cypress, Scots pi...
T Osawa, R Noda, K Yamamoto
Field test method for wood in above ground situation - The full CEN/TC 38 guideline for the Sandwich method. Part 1 - Determining the relative protective effectiveness of a wood preservative
2024 - IRG/WP 24-41013
The attached draft CEN Technical Specification (i.e. pre-EN standard) has been drafted in order to become an alternative to the Lap-Joint test method (EN 12037:23) for testing of wood in above ground situation and the draft CEN/TS Part 1 is specifically intended for determining the relative protective effectiveness of a wood preservative. The new draft CEN/TS is based on a test method developed by...
M Westin, R Ringman, A Christof, F Friese
Levels of chromated copper arsenate in aged radiata pine vineyard posts
2024 - IRG/WP 24-50389
At the Centre for Timber Durability and Design Life, Australia a cooperative project is underway with Forest and Wood Products Australia, supported by a consortium of timber producers, chemical suppliers and timber users to identify alternative pathways for treated timber and EWP’s. Under this initiative, we are focusing on establishing the current and forecasting future volumes of treated timbe...
T Singh, T Yi, P Mitchell, J Norton
Quantitative assessment of wood preservative emissions to waterways
2024 - IRG/WP 24-50393
The Organisation for Economic Co-operation and Development (OECD) Emission Scenario Document (ESD) for Wood Preservatives provides methods to quantify the release of active substances from treated wood for various scenarios including sheet pilings in a flowing waterway (OECD 2013). The ESD is used for environmental risk assessment of wood preservatives according to the Biocidal Products Regulation...
K J Rader, R Carbonaro, C Mackie
Multifactorial analysis of the reasons behind wood natural durability
2025 - IRG/WP 25-11065
Physical, chemical and biological properties of several wood species were investigated in order to highlight the main factors involved in wood natural durability and wood characteristic using a principal component analysis. Interaction of wood with water were evaluated using contact angle measurements to determinate wood wettability by water and wood impregnability tests with water allowing to cal...
L-F E Nkogo, M S M Mouendou, S Dumarçay, P E Engonga, F Zannini, E Gelhaye, P Gérardin
Natural and enhanced durability of wood exposed above ground
2025 - IRG/WP 25-11079
Understanding and predicting the durability of wood is essential for ensuring its effective use, long-term reliability, and sustainability in various applications. To address this need, the "Wood Above Ground" project was initiated in 1999 at the Danish Technological Institute (DTI) to investigate the natural durability of wood species under a wide range of above-ground exposure scenarios. This ex...
R Digaitis, J Stenbaek, A W Christof, N Morsing, B Lindegaard
Securing Flame Retardancy in Wood: Durability After Artificial and Natural Weathering Test
2025 - IRG/WP 25-20738
The outdoor use of wood is often limited by challenges such as dimensional instability, vulnerability to fungal decay, and high flammability. Traditional flame retardant treatments improve fire resistance but suffer from significant leaching under environmental exposure, reducing their long-term effectiveness. This study introduces an innovative solution by integrating flame retardants with DMDHEU...
M Wu, L Martin, H Militz
Evaluation of 'Deep Penetration Treatment' for wood preservation
2025 - IRG/WP 25-20746
‘Deep Penetration Treatment’ (DPT) is a recently developed wood preservation technique in Japan designed to meet the preservation standards required for residential foundations. This method involves spraying a specially formulated solvent-borne wood preservative onto properly incised dried lumber. Despite being a non-pressure treatment, DPT achieves penetration levels comparable to conventiona...
M Ikeda, T Shigeyama, Y Sugai
Influence of incising methods and wood moisture content on ‘deep penetration treatment’ in Japanese cedar and larch
2025 - IRG/WP 25-20749
To expand applicability of ‘deep penetration treatment’, a solvent-borne and non-pressure treatment that is commonly coupled with roller-type incising using a flat blade, we investigated drill and laser machining as alternative incising methods and examined the influence of wood moisture content on the preservative penetration. Various incising methods were applied to heartwood of Japanese ced...
S Taira, T Miyauchi, S Isaji, H Matsunaga
NTR classified preservative-treated laminated wood
2025 - IRG/WP 25-20750
NTR is a trusted quality labelling system used for the classification and quality control of wood products that have been treated with preservatives or modified. These labels are issued by the Nordic Wood Preservation Council (NWPC) and in recent years, producers of glued laminated timber as well as building material suppliers have shown increasing interest in NTR classification for glued laminate...
J Jermer, F Westin, R Digaitis
The impact of common fire retardancy salts and minerals on further properties of wood
2025 - IRG/WP 25-30821
Wood has become an increasingly important construction material. To ensure fire safety, fire retardants are widely applied. Recent research focuses on environmentally friendly fire retardants with strong fixation. Phosphate-based salts like diammonium hydrogen phosphate show high fire protection potential but are highly leachable due to their good water solubility. As a newer trend mineralisation ...
T Franke, T Volkmer
Evaluation of oak bark extracts as bio-based preservative agents in wood protection
2025 - IRG/WP 25-30833
Bark represents a major by-product of the forestry sector and is often referred to low value uses such as combustion for energy, soil mulching or animal bedding. Nevertheless, bark contains a wide array of bioactive constituents, offering considerable potential for transformation into value-added wood protection agents. Developing sustainable wood treatments based on these natural compounds aligns...
R Herrera, A Selmanovic, F Poohphajai, C Peña, A Sandak
Evaluation of moisture exclusion ability of wood using double-layer outdoor exposure tests
2025 - IRG/WP 25-41021
The material resistance of wood to decay must be due to the combined effects of heartwood extractives and the moisture content state. Evaluating the moisture exclusion ability of wood is important for assessing its durability in outdoor use. We conducted previously double-layer outdoor exposure tests and investigated the relationship between moisture content over time and the progress of decay usi...
T Osawa, R Noda, K Yamamoto
Non-destructive methods for field assessment of wood biodeterioration in hardwood trailer decks exposed to tropical environments
2025 - IRG/WP 25-41039
Apitong (Dipterocarpus spp.), an increasingly rare tropical hardwood from the rainforest in Southeast Asia, has long been used as decking materials for open-bed trailers and trucks across North America. As the natural population of Apitong trees steadily declines, there is an urgent need to find sustainable, domestically sourced alternatives for trailer decking. A recent project evaluated the perf...
X Wang, X Xie, G Kirker, C A Senalik
Developing a Novel Bio-based PF Resin as Wood Preservative and Explore its Synthesis Route Using RSM Methodology
2025 - IRG/WP 25-41046
Phenol-formaldehyde (PF) resin treatment has long been recognized as one of the most effective and widely used wood preservation methods, offering exceptional durability, dimensional stability, and resistance against biological degradation. However, traditional PF synthesis relies heavily on petroleum-derived phenol, raising concerns about environmental impact and resource sustainability. To date,...
H-C Ye, Y-C Wu, T-H Lin, P-Y Kuo
Investigation of Pressure-Treated Foundations with Wood Preservative and Termite Control in Existing Wooden Houses in Japan
2025 - IRG/WP 25-50402
Japan has extremely limited natural resources. Therefore, it is necessary to build a circular economy in which waste and other recyclable resources are effectively utilized in order to achieve sustainable development. This study aims to investigate the degradation of existing wooden houses and to contribute to the reuse of existing houses and the reuse of building materials during demolition. We i...
K Usami, T Kawada, H Ishiyama
Contribution of naturally durable wood use to Circular Economy - Understanding the classification system of natural durability and its variation within wood species
2025 - IRG/WP 25-50411
Total wood demand is shown by FAO to increase 49 percent between 2020 and 2050, regardless of deteriorating conditions such as deforestation and degradation due to fire and biological damages. Demand for wood as a building material is also projected by UNEP to increase significantly to 300 Gt in 2040. To address this situation, extension of the service life and re-use of wood are expected to make ...
K Yamamoto, T Osawa, R Noda
Danish wood preservatives approval system with special focus on assessment of the environmental risks associated with industrial wood preservatives
2001 - IRG/WP 01-50166-01
The following is a description of the procedure used by the Danish Environmental Protection Agency to assess the environmental risks associated with preservatives used in the pressure impregnation of wood. The risk assessment covers issues considered to be of significance for the environment and which are adequately documented so as to allow an assessment. Such issues are persistence and mobility ...
J Larsen
Data sheet on wood-boring insects. Apate monachus Fabricius. 2. Position systématique, nomenclature, identification et distribution - Espèces végétales attaquée
1981 - IRG/WP 1105
R L A Damoiseau
Proposal for further work on accelerated ageing
1988 - IRG/WP 2314
M-L Edlund
Effect of acetylation on decay resistance of wood against brown-rot, white-rot and soft-rot fungi
1989 - IRG/WP 3540
Effect of acetylation on decay resistance of wood was investigated using wood blocks of Cryptomeria japonica, Pinus densiflora, Albizia falcata and Fagus crenata. Blocks were treated with uncatalyzed acetic anhydride for different lengths of time and exposed to Tyromyces palustris, Serpula lacrymans, Coriolus versicolor and unsterilized soil. The action of OH-radical on acetylated wood was also ex...
M Takahashi, Y Imamura, M Tanahashi
The IRG..Chanelling information and ideas into the mainstream of wood preservation technology
1985 - IRG/WP 5241
IRG Secretariat
Wood preservation in Poland
2004 - IRG/WP 04-30362
Dynamic growth of market demand for wooden elements and articles, generated in Poland increase of interest in industrial preservation. Today, Poland is a substantial producer and exporter of wood made products. Majority of exported wood - approximately 70% - is scotch pine (Pinus silvestris L.), which, due to its natural durability, requires preservation....
A Kundzewicz
Wood preservatives: Field tests out of ground contact. Brief survey of principles and methodology
1976 - IRG/WP 269
This paper contains the following spots:
1.: The general need for field tests. 2.: Interests and limits of field tests in ground contact. 3.: Various methods in use for out-of-ground contact field tests. 4.: Fungal cellar tests are they an alternative to above-ground decay exposure tests? 5.: Conclusions....
M Fougerousse
Management of the wood and additives wastes in the wood processing industries: Problematics and technical answers review
1996 - IRG/WP 96-50073
Management pathways for pure wood subproducts are well known and used; but as soon as additives like preservatives, glues, varnishes or coatings are present within the wood wastes, their disposal or valorization becomes more tricky. The different kinds of mixed wood wastes of the wood processing industries, from the sawmill to the furniture manufacture, are identified herewith and their diversity ...
S Mouras, G Labat, G Deroubaix