Your search resulted in 674 documents. Displaying 25 entries per page.
Envelope wood protection against subterranean termites under H2-hazard class tropical environment by a new generation wood preservative with vegetal extracts-cypermethrin mixtures
2023 - IRG/WP 23-30795
Wood protection industries in progressive economies globally are compelled to develop cost-effective, environmentally acceptable wood treatment solutions for long term carbon storage in wood materials/products while appealing to consumer demands for low environmental impact treated wood. A new generation wood preservative, based in part on 2% vegetal extracts and 0.16% cypermethrin components, has...
D Messaoudi, A H H Wong
Longitudinal tensile shear properties of polyurethane-bonded preservative-impregnated Eucalyptus grandis laminates subjected to varied simulated climatic conditions
2023 - IRG/WP 23-40967
Bonding process adaptations have yielded improvements in the adhesive bonding of Eucalyptus grandis wood for manufacturing hardwood laminates. However, there are still concerns over the adhesive-bond performance, particularly preservative-impregnated E. grandis laminates, under exposure to varying climatic conditions. These concerns could limit the implementation of E. grandis laminates, especiall...
A A Alade, C B Wessels
The appropriateness of central one-ninth or core retentions as a means of demonstrating penetration compliance
2023 - IRG/WP 23-40976
Treatment quality is in general terms dependent upon the preservative retention, and how the preservative is distributed throughout the cross-section of the treated article in question, i.e. the penetration of the preservative. Of these two fundamental qualities that are intrinsically linked to treatment quality, penetration is in general terms the most subjective. The determination of retention i...
D Humphfrey, B Skewes
Effects of preservative impregnations on wettability and surface free energy properties of Eucalyptus grandis wood
2023 - IRG/WP 23-40978
Wettability and surface free energy (SFE) are crucial parameters for evaluating the adhesion thermodynamics of solid surfaces. Hence, this study investigated the effects of copper azole (CA) and disodium octaborate tetrahydrate (DOT) preservative impregnations on Eucalyptus grandis wood wettability and SFE. Wettability was determined in terms of contact angles with polar (water) and non-polar (dii...
A A Alade, C B Wessels, H Stolze, H Militz
Evaluation of the effectiveness of soaking of high-temperature plywood in low-temperature oil-based wood
2023 - IRG/WP 23-40991
We conducted a preliminary investigation to determine if soaking high-temperature plywood in a low-temperature preservative solution could achieve deeper penetration of the preservative, even in plywood made with refractory wood species such as Japanese larch. Specimens cut from commercial plywood (Japanese larch) were stored at various temperatures before being soaked in the preservative solution...
T Miyauchi, S Isaji, H Shibui, N Furuta, J Miyazaki, H Matusnaga
Recent experiences in the protection of wooden cultural heritage in Europe with a novel wood preservative with vegetal extracts–permethrin-azole mixture
2023 - IRG/WP 23-11027
The paper presents recent treatment experiences in Europe for the preservation of cultural heritage with the bio-based gel-emulsion solution XILIX® containing SYNERKEM® technology, whose higher diffusion capacity has been proven (up to 8 mm pyrethroid penetration into the wood). This gel-emulsion is already authorized and marketed as preventive and remedial wood preservative in Europe for more t...
D Messaoudi, A Robert, A H H Wong
Why preserved wood is used for infrastructure
2024 - IRG/WP 24-20711
This article provides an overview of the reasons why preservative-treated wood, and creosote-treated wood in particular, products have been and continue to be selected for the infrastructure of civilization. Wood is a remarkable and renewable building material, offering high strength, light weight, flexibility, and availability. Preservation by creosote treatment adds great durability to the woo...
S T Smith
Comparison of copper leaching from alkaline copper quat and copper compound nanosol-based wood preservative treated wood
2024 - IRG/WP 24-20726
To improve the leaching resistance of copper ion-based wood preservatives, copper compound nanosol-based wood preservatives were developed and its copper leaching characteristics were evaluated. Three types of preservatives (DC1, DC2, DC3) were prepared with different crystallinity and dispersant types of copper compound nanosol, and the copper concentration was adjusted to be the same as that of ...
Y-S Choi, S-M Yoon, J O Kim, J-G Kang, J-G Park
A new wood preservative system based on basic copper compound nanosols
2024 - IRG/WP 24-20728
A bottom-up process was established to synthesize insoluble basic copper compound nanoparticles and simultaneously form a stable nanosol by dropping a neutralizing agent solution into an aqueous solution of a copper compound to which an appropriate dispersant system was added. The main ingredient of MCA (Micronized Copper Azole), the leading copper-based wood preservative in the current world mark...
J O Kim, J-G Kang, Y-S Choi, S-M Yoon, H-M Lee, J-G Park
Field test method for wood in above ground situation - The full CEN/TC 38 guideline for the Sandwich method. Part 1 - Determining the relative protective effectiveness of a wood preservative
2024 - IRG/WP 24-41013
The attached draft CEN Technical Specification (i.e. pre-EN standard) has been drafted in order to become an alternative to the Lap-Joint test method (EN 12037:23) for testing of wood in above ground situation and the draft CEN/TS Part 1 is specifically intended for determining the relative protective effectiveness of a wood preservative. The new draft CEN/TS is based on a test method developed by...
M Westin, R Ringman, A Christof, F Friese
Copper migration from preservative-treated Douglas-fir decking: models vs laboratory leaching data
2024 - IRG/WP 24-50390
The ability of a model to predict copper migration from Douglas-fir treated with organic metallic substances into a freshwater slough was evaluated against data generated through simulated overhead leaching. The model predicted very high loadings of ammoniacal copper zinc arsenate, alkaline copper quaternary or copper azole that had the potential to impact water quality while data from the exper...
M J Konkler, G Presley, J J Morrell, T Singh
Quantitative assessment of wood preservative emissions to waterways
2024 - IRG/WP 24-50393
The Organisation for Economic Co-operation and Development (OECD) Emission Scenario Document (ESD) for Wood Preservatives provides methods to quantify the release of active substances from treated wood for various scenarios including sheet pilings in a flowing waterway (OECD 2013). The ESD is used for environmental risk assessment of wood preservatives according to the Biocidal Products Regulation...
K J Rader, R Carbonaro, C Mackie
Mitigating the risk of decay in CLT buildings affected by trapped construction moisture using a diffusible borate preservative
2025 - IRG/WP 25-20735
Cross-Laminated Timber (CLT) is also known as a mass timber construction material. It is fabricated by gluing together multiple layers of timber lamellae with each layer oriented perpendicular to the one below it. This enhances strength, stability and dimensional rigidity. CLT is seen as an excellent ‘low carbon’ alternative to using steel and concrete and is growing in popularity as a sustain...
J R Williams
Transmission poles - Analysis of causes of premature failure in Slovenia
2025 - IRG/WP 25-20745
The study focuses on analysing the causes of the premature collapse of wooden transmission poles in Slovenia, where there have been several cases of rapid fungal decomposition of poles despite the planned lifespan of 30 to 50 years. The poles were made of Scots pine wood and impregnated with a copper-ethanolamine wood preservative. The research aimed to assess the condition of standing poles and e...
M Humar, B Lesar, N Kregar, S Drnovšek
Evaluation of 'Deep Penetration Treatment' for wood preservation
2025 - IRG/WP 25-20746
‘Deep Penetration Treatment’ (DPT) is a recently developed wood preservation technique in Japan designed to meet the preservation standards required for residential foundations. This method involves spraying a specially formulated solvent-borne wood preservative onto properly incised dried lumber. Despite being a non-pressure treatment, DPT achieves penetration levels comparable to conventiona...
M Ikeda, T Shigeyama, Y Sugai
Influence of incising methods and wood moisture content on ‘deep penetration treatment’ in Japanese cedar and larch
2025 - IRG/WP 25-20749
To expand applicability of ‘deep penetration treatment’, a solvent-borne and non-pressure treatment that is commonly coupled with roller-type incising using a flat blade, we investigated drill and laser machining as alternative incising methods and examined the influence of wood moisture content on the preservative penetration. Various incising methods were applied to heartwood of Japanese ced...
S Taira, T Miyauchi, S Isaji, H Matsunaga
NTR classified preservative-treated laminated wood
2025 - IRG/WP 25-20750
NTR is a trusted quality labelling system used for the classification and quality control of wood products that have been treated with preservatives or modified. These labels are issued by the Nordic Wood Preservation Council (NWPC) and in recent years, producers of glued laminated timber as well as building material suppliers have shown increasing interest in NTR classification for glued laminate...
J Jermer, F Westin, R Digaitis
The iTrussT project – Advancements in timber bridge design, preservation, and monitoring
2025 - IRG/WP 25-20751
The Norwegian research project iTrussT (2025–2028) aims to advance timber bridge design and unlock wood’s full potential as a sustainable solution for modern infrastructure. It addresses three critical challenges: First, fatigue testing of glued laminated timber lamellae will provide deeper insights into shear failure mechanisms, supporting the development of safer, more efficient structures a...
K-C Mahnert, U Hundhausen
Evaluation of oak bark extracts as bio-based preservative agents in wood protection
2025 - IRG/WP 25-30833
Bark represents a major by-product of the forestry sector and is often referred to low value uses such as combustion for energy, soil mulching or animal bedding. Nevertheless, bark contains a wide array of bioactive constituents, offering considerable potential for transformation into value-added wood protection agents. Developing sustainable wood treatments based on these natural compounds aligns...
R Herrera, A Selmanovic, F Poohphajai, C Peña, A Sandak
Validation of a measurement method for cyproconazole retention in pressure-treated wood through an interlaboratory study
2025 - IRG/WP 25-41037
The Japanese Agricultural standard (JAS) defines national regulations for preserved wood and wooden materials, in Japan. Traditionally the JAS focused on quality of product, however, the revision of the JAS Act in 2017 enabled standardisation of test or measurement method for the quality evaluation. The Japan Wood Protection Association (JWPA) has been working toward standardisation of methods for...
T Miyauchi, Y Itou, M Samejima
Non-destructive methods for field assessment of wood biodeterioration in hardwood trailer decks exposed to tropical environments
2025 - IRG/WP 25-41039
Apitong (Dipterocarpus spp.), an increasingly rare tropical hardwood from the rainforest in Southeast Asia, has long been used as decking materials for open-bed trailers and trucks across North America. As the natural population of Apitong trees steadily declines, there is an urgent need to find sustainable, domestically sourced alternatives for trailer decking. A recent project evaluated the perf...
X Wang, X Xie, G Kirker, C A Senalik
Developing a Novel Bio-based PF Resin as Wood Preservative and Explore its Synthesis Route Using RSM Methodology
2025 - IRG/WP 25-41046
Phenol-formaldehyde (PF) resin treatment has long been recognized as one of the most effective and widely used wood preservation methods, offering exceptional durability, dimensional stability, and resistance against biological degradation. However, traditional PF synthesis relies heavily on petroleum-derived phenol, raising concerns about environmental impact and resource sustainability. To date,...
H-C Ye, Y-C Wu, T-H Lin, P-Y Kuo
Investigation of Pressure-Treated Foundations with Wood Preservative and Termite Control in Existing Wooden Houses in Japan
2025 - IRG/WP 25-50402
Japan has extremely limited natural resources. Therefore, it is necessary to build a circular economy in which waste and other recyclable resources are effectively utilized in order to achieve sustainable development. This study aims to investigate the degradation of existing wooden houses and to contribute to the reuse of existing houses and the reuse of building materials during demolition. We i...
K Usami, T Kawada, H Ishiyama
Bio-Based but Toxic? The Neglected Ecotoxicity of Leachates from Wood Preservatives—A mini-review
2025 - IRG/WP 25-50403
Bio-based Wood preservatives, derived from renewable biomass, are emerging as promising alternatives to traditional synthetic wood preservatives. Research groups all around the world are studying the development of bio-based – environmentally friendly – wood preservatives and their fixation to wood finding natural compounds with very promising wood preserving potential. However, there is a ver...
A Barbero-Lopez, A Haapala