Your search resulted in 28 documents. Displaying 25 entries per page.
Evaluation of rapid methods for detecting wood preservatives in waste wood
1994 - IRG/WP 94-50024
For the disposal of wood waste under ecological sound conditions information about its hazardous potential is required. Several analytical methods are available for the detection of most elements in wood preservatives. Industrial process conditions, however, demand methods with very short turn around times. In this research several methods of analysis were judged on their speed and accuracy. A num...
W J Homan, H Militz
Confocal laser scanning microscopy of a novel decay in preservative treated radiata pine in wet acidic soils
1997 - IRG/WP 97-10215
Light microscopy of radiata pine (Pinus radiata D. Don) field test stakes (20x20x500mm3) exposed in wet acidic (pH 3-4) soil for 12 - 24 months showed predominance of an unusual type of decay characte-rised by tunnelling attack of wood cell walls. After two years decay was moderate to severe in wood treated to ground contact CCA specifications and also equivalent retentions of creosote, and a numb...
R N Wakeling, Ying Xiao, A P Singh
Quantitative determination of Chromium: A comparison of three instruments
1995 - IRG/WP 95-50053
A comparison is made between three instruments for measuring levels of chromium in the leachate of copper-chrome-arsenic (CCA) treated timber. These include an atomic absorption spectrophotometer, an inductively coupled plasma spectrometer and the RQflexâ. The RQflexâ is a new hand-held instrument which measures chromium by dipping a ReflectoquantÒ strip into the leachate and inserting the stri...
S Walley, P R S Cobham, P Vinden
Chemical analyses of IRG/COIPM INTERNATIONAL MARINE TEST (to determine the effect of timber substrate on the effectiveness of water-borne salt preservatives in sea-water) samples
1987 - IRG/WP 4114
Chemical analysis of CCA and CCB treated timber was carried out after exposure at tropical and temperate marine sites. Results indicated that losses of all elements had occurred. In particular, losses of boron were severe. Arsenic and copper were also lost. The chromium components in both formulations was the most dominant metal remaining. The results suggest that chromium modification was importa...
L E Leightley
The use of immunofluorescence labelling for detecting Ophiostoma piceae in radiata pine
1998 - IRG/WP 98-10268
The primary objective of the current investigation is to understand fungal interactions of dominant sapstaining fungi in radiata pine using confocal laser scanning microscopy (CLSM).
In the current paper, an immunofluorescence labelling technique was developed for detection of Ophiostoma piceae using a monoclonal antibody. The primary antibody was labelled with Oregon green 514 Goat anti-mouse Ig...
Ying Xiao, B Kreber, C Breuil
A comparison of inductively coupled plasma spectroscopy and neutron activity analysis for the determination of concentrations in wood
1993 - IRG/WP 93-10048
As wood decays the ionic composition changes, with increases often being seen in the concentrations of Ca, Mg, Fe, Mn and sometimes K. The concentration of eight cations in red spruce sapwood and heartwood samples was determined independently by inductively coupled plasma spectroscopy (ICP) and by neutron activation analysis (NAA) as part of an effort to standardize our analytical procedures and c...
J Jellison, J Connolly, K C Smith, W T Shortle
Distribution of copper/chrome/boron preservative in light red meranti (Shorea leprosula) before and after exposure test for 72 months
1995 - IRG/WP 95-20073
Copper/chrome/boron (CCB) preservative at 6% w/w was impregnated into light red meranti (Shorea leprosula) by full cell process. The quantitative analysis for copper, chrome and boron contents in treated wood samples was carried out by Inductive Couple Plasma (ICP). Electron Probe Microanalyser (EPMA) was used to monitor the distribution of copper, chrome and boron in the various treated wood tiss...
S Salamah, S Ani
Confocal Laser Scanning Microscopy (CLSM) of decayed wood
1998 - IRG/WP 98-10273
Confocal laser scanning microscopy (CLSM) is currently being used to examine biodegraded wood and is proving to be a useful new technique in this area of work. Non-invasive optical sectioning within a thick specimen (20 - 50 µm), coupled with post image processing techniques allows manipulation of images and 3-D reconstruction from serial sections.
Glutaraldehyde can cause cell autofluorescence,...
Ying Xiao, R N Wakeling, A P Singh
A review of incising as a means of improving treatment of sawnwood
1994 - IRG/WP 94-40019
The use of incising, perforation of the wood surface, is increased because of the need to treat refractory wood species. This paper reviews the development of incising and shows how the required incising patterns can be determined and specified. Most of the development has been in the area of toothed-roller incisors because of their rapid throughput. Needle, Laser, drill and water jet incisors hav...
P I Morris, J J Morrell, J N R Ruddick
Visualising Bacteria in Wood Using Confocal Laser Scanning Microscopy (CLSM)
1998 - IRG/WP 98-10272
A fluorescent phospholipid probe was used in conjunction with confocal laser scanning microscopy (CLSM), to visualise bacteria which inhabit in radiata pine wood and degrade pit membranes. CLSM has the ability to collect fluorescent images through different emission filters at the same time, so it is possible to distinguish gram-positive and gram-negative bacteria in infected wood by counterstaini...
Ying Xiao, A P Singh, R N Wakeling
Microwave digestion of preserved wood for the determination of Cu, Cr, As, B and P in quality control
1991 - IRG/WP 2364
A microwave digestion method for the determination of copper, chromium, arsenic, boron and phosphorus in preserved woods is described. Samples were digested with nitric acid in pressure-relief type teflon PFA vessels by microwave heating in a commercial laboratory microwave oven. Fast, efficient and complete digestion was achieved within 29 min for 12 samples. The digestion time compared favourabl...
N Bernth, L B Sheard
Formation of polychlorinated dibenzo-p-dioxins (PCDD) and polychlorinated dibenzofurans (PCDF) during the combustion of impregnated wood
1995 - IRG/WP 95-50040-19
Wood waste and industrial wood residues often contain various preservatives. The waste management for these residuals can be recycling, deposition or combustion. Among the three possibilities, combustion seems to be the most efficient way of disposal. To obtain detailed information about emissions of organic compounds with environmental impact, especially polychlorinated dibenzo-p-dioxins (PCDD) a...
T Salthammer, H Klipp, R-D Peek
Investigations into the biology of Meruliporia incrassata
2004 - IRG/WP 04-10508
The dry rot fungus Meruliporia incrassata (Berk. and Curt.) Murr. is a highly destructive brown rot wood decay fungus and is a significant pest of wooden structures. The fungus, know commonly as ‘Poria’, is characterized in culture by strand mycelium and skin-like surface mycelium. In structural environments it is found to produce prominent water conducting rhizomorphs, is a copious spore prod...
J Jellison, C Howell, B Goodell, S L Quarles
A comparison of analytical techniques
1995 - IRG/WP 95-20061
This paper compares carefully-controlled weight retentions and analysis by XRF, ICP, combustion methods and a new extraction procedure for the new preservative, Copper(II) Dimethyldithiocarbamate (CDDC). Various experimental parameters such as particle size and drying conditions were investigated. In general, the correlations between and among the procedures are very high. The extraction-colorimet...
A C Gallacher, C R McIntyre, M H Freeman, D K Stokes, W B Smith
Investigation of CCA fixation in wood by sequential extraction. I Determination of CCA component fixation and preliminary extraction results
2002 - IRG/WP 02-50188
The fixation of CCA-C preservative was investigated in sapwood of red pine (Pinus resinosa Ait.), trembling aspen (Populus tremuloides Michx.) and red maple (Populus tremuloides Michx.) at target retentions of 4.0, 6.4, 9.6 and 30.0 kg/m3. Treated wood sawdust was water extracted at close time intervals during the fixation and analyzed for the contents of unfixed hexavalent chromium, total Cr, Cu ...
S Radivojevic, P A Cooper
Kinetics of the dissociation of Cr, Cu, and As in fixed CCA-treated wood
2001 - IRG/WP 01-50168
The results of an experiment showing the kinetics of the dissociation of CCA compo-nents in water within treated wood samples are presented. Dry red pine (Pinus resinosa Ait.) samples were simultaneously vacuum-treated with water, then expressed to re-move the water at successive time intervals. The expressate was then analyzed for Cr, Cu, and As concentration by inductively coupled plasma (ICP). ...
L Waldron, P A Cooper
Laser incising of spruce lumber for improved preservative penetration
1991 - IRG/WP 3646
Red spruce heartwood specimens were incised using a range of laser beam power levels and pulse durations. The penetration of CCA through these holes into the wood was monitored after pressure treatment. In addition, green and dried spruce samples were incised using two patterns with incision densities of either 16.1 holes/in² or 21.3 holes/in². Following CCA pressure treatment the samples were t...
B Goodell, F A Kamke, Jing Liu
The extraction of boron from treated wood for quantitative analysis: A comparison of procedures
1992 - IRG/WP 92-2414
The extraction of boron preservative from treated rubberwood and scots pine samples was compared using methods based on refluxing and extraction in 1N NaOH or distilled water at 80°C. The extract solutions were analysed by Inductively Coupled Plasma spectroscopy (ICP/AES). A simple extraction procedure based on immersion of wood samples of approximate dimension 2 x 1 x 1 cm³ in distilled water a...
R J Murphy, D J Dickinson, P W McCormack, M K Lung
CCA type C depletion of Southern yellow pine utility poles
1995 - IRG/WP 95-50049
Depletion and redistribution of preservative components were evaluated on five CCA-C treated poles in service for over six years in Conley, Georgia. A statistical approach was taken in which retentions below ground were compared to retentions above ground due to a lack of initial data on individual poles. It was hypothesized that the below ground retentions should be lower than the corresponding a...
P D Osborne, R F Fox
Quantification of methylene bis thiocyanate in wood and its effect on a sapstain fungus Ophiostoma floccosum
2006 - IRG/WP 06-10591
The mobility and concentrations of MBT at different depths of wood billets (200 mm long, 40 mm in diameter) were determined using NMR spectroscopy and ICP-ASE, and then correlated the effect of wood MBT concentrations on growth of O. floccosum in a bioassay using stereomicroscopy and confocal laser scanning microscopy (CLSM).
The 13C NMR spectra showed the presence or absence of MBT in wood but w...
T Singh
Comparative study between full cell and passive impregnation method of wood preservation for laser incised Douglas-fir lumber
2007 - IRG/WP 07-40359
Many wood species are highly resistant to conventional pressure treatment. To improve the chemical impregnation into Douglas-fir (Pseudotsuga menziesii Franco) lumber, the passive impregnation method had been developed. In this study, ability of the passive impregnation for lumber was compared with a conventional full cell method. Square Douglas-fir lumber with the incising density of 10,000 holes...
Md N Islam, K Ando, H Yamauchi, Y Kobayashi, N Hattori
Laser stain removal of fungus-induced stains on paper-based cultural relics
2007 - IRG/WP 07-40389
Laser techniques has been developed and applied in commercial use for 40 years, but it has not been used successfully to remove stains from paper-based cultural relics . The purpose of this study was to investigate the paper cleaning by using a technique of Nd-YAG laser. Artificial stained papers were inoculated with fungi and then were treated at different laser cleaning parameters, in order to f...
Tsang-Chyi Shiah, Han Chien Lin
Effects of Moisture Content and Species on Penetration of Liquid in Laser Incised Lumber by the Passive Impregnation Method
2008 - IRG/WP 08-40408
Penetration of liquid by passive impregnation method for Douglas-fir (Pseudotsuga menziesii Franco), sugi (Cryptomeria japonica D. Don) and Japanese larch (Larix leptolepis Gordon) were studied. Effects of initial moisture content of sugi (16, 43 and 70% moisture content) on liquid penetration by the method were also studied. Dried Douglas-fir and sugi, and green Japanese larch and sugi were treat...
N Hattori, M Nazrul Islam, K Ando, H Yamauchi
Analyzing hyphal growth of the bio incising fungus Physisporinus vitreus with light-, confocal laser scanning- and, Synchrotron X-ray tomographic microscopy
2010 - IRG/WP 10-20438
Norway spruce wood is an important building material for the forest and wood industry. To improve wood permeability and uptake of wood modification substances Physisporinus vitreus is employed as a bioincising agent. In this study wood specimens were incubated with P. vitreus to assess hyphal colonisation and structural alterations of Norway spruce wood. After different incubation periods, semi-th...
C Stührk, M Fuhr, M Schubert, F W M R Schwarze
Classification of wood materials using Fourier Transform Near Infrared Spectroscopy and multivariate analysis
2011 - IRG/WP 11-20471
A distinction between preservative-treated wood and non-treated wood can be demonstrated by the combination of Fourier Transform-Near Infrared Spectroscopy (FT-NIRS) and Multivariate Analysis (MVA). This technique is non-destructive, quick, easy to use and can be portable. The calibration models for different heavy metals are set up using principal component analysis (PCA) to classify species of t...
M A Bouslamti, M A Irle, C Belloncle, V Salvador, S Hulot, B Caron, E M Qannan