Your search resulted in 32 documents. Displaying 25 entries per page.
Microcapsule formulation of fenitrothion as a soil termiticide
1991 - IRG/WP 1478
The efficacy and the mode of action of a microcapsule formulation of fenitrothion against Coptotermes formosanus Shiraki were investigated. The physicochemical property that this formulation does not allow the active ingredient to diffuse through the capsule wall contributed to a long lasting efficacy and safety for the men spraying. The residual effect of the fenitrothion microcapsule in soil was...
H Teshima, T Itoh, Y Abe
Rates of emission from CCA-treated wood in the marine environment: measurement, modelling and requirements for further research
2001 - IRG/WP 01-50166-12
Accurate estimates of rates of emission of leachate from preservative treated wood are crucial for realistic predictions of the environmental impact of its use in maritime construction. Estimates are available for some commonly used preservatives, but these vary widely. Though variable, these measurements suggest that emission generally decreases exponentially with time. Part of the variation is d...
S M Cragg, C J Brown, R A Albuquerque, R A Eaton
Penetration of deltamethrin in micro-emulsion formulation after injection in wood
1996 - IRG/WP 96-40068
In the Netherlands (and some other European Countries) the remedial treatment of death watch beetle is still a problem. This is because the larvae of this insect penetrate the central heartwood of mainly large oak beams. The heartwood is difficult to treat. The preventive treatment of wood boring insects has only recently been permitted in the Netherlands. Since 1989 injection of insecticides is r...
P Esser, W L D Suitela
Some tests on ES - AS 11, a novel anti-sapstain formulation, and its properties
1987 - IRG/WP 3399
The results of some tests with the formulation ES - AS 11 are given. The formulation is an attempt to improve the performance of an anti-sapstain chemical by: 1) increasing its penetrability 2) uniquely combining its active ingredients. Very short times of treatment (dipping not longer than 5 seconds), low concentrations of active ingredients, and lower toxicological and environmental risks may be...
The influence of formulation on the behaviour of LOSP's during industrial impregnation of spruce
1986 - IRG/WP 3387
Evidence is presented that the comparative behaviour of two LOSP formulations during impregnation treatment of spruce cannot be predicted purely on the basis of their physical characteristics (viscosity, surface tension and contact angle) nor on the extent of their 'passive' penetration into pine sapwood....
L D A Saunders, D M Zuvencko
Conditions and possibility of nanobiocides formulation for wood protection
2008 - IRG/WP 08-30467
During development of nanobiocides for wood protection the need to identify mineral composition of wood in respect of trace elements and nourishing conditions of wood destroying fungi in relation to these elements was discussed....
J Wazny, A Kundzewicz
Laboratory evaluation of chlorothalonil formulation for stain and mold control on rubberwood and maple
1998 - IRG/WP 98-30175
We evaluated the efficacy of several chlorothalonil and carbendazim fungicides (F1 and F2), etc. in the control of mold and stain fungi on rubberwood and maple. The results showed that these formulations effectively inhibited the selected fungal species such as Aspergillus niger, Penicillium sp., Trichoderma sp. (P71H), Aureobasidium pullulans, Ceratocystis minor (C-188), Ceratocystis pilifera (RW...
Mingliang Jiang, T L Highley, L Ferge, T L Woods
A laboratory bioassay on the termiticidal efficacy of a chlorothalonil formulation and a chlorothalonil plus chlorpyrifos formulation to Mastotermes darwiniensis Frogatt
1993 - IRG/WP 93-30004
Results of a laboratory bioassay on the efficacy of two preservative formulations (chlorothalonil in oil; chlorothalonil plus chlorpyrifos in oil) to the Australian subterranean termite Mastotermes darwiniensis Froggatt are given. Specimens of Pinus radiata D. Don sapwood were treated to three retentions of each formulation to achieve 3.2, 6.4 and 12.8 kg/m³ of chlorothalonil a.i. and 3.2 + 0.2, ...
J W Creffield, N Chew
Preservative treatments of window components with a water-based borate formulation
2000 - IRG/WP 00-40171
Factory finished window joinery components were treated with an aqueous borate preservative in order to investigate penetration and retention levels, associated drying times; and the potential impact of using a water-based treatment on finished items. It was found that by using borates applied by light double vacuum schedules, it was possible to meet standards for penetration and retention, to air...
J Jermer, J D Lloyd
Properties of plywood and Oriented Strand Board manufactured with an organic insecticide incorporated in the adhesive formulation
2000 - IRG/WP 00-40174
The efficacy of Fipronil as an insecticide has been established by laboratory and field experiments and commercial use against a broad range of insect pests for various crops. It can be used by either foliar or soil application. Development is underway for the non-agricultural uses of fipronil. Research is ongoing for the control of ants, cockroaches, fleas, ticks, houseflies, mosquitoes, termites...
D P Kamdem, J H Hope, A Jermannaud
Sentry®, a new antisapstain formulation for protecting logs and lumber. - Part 2: protection of lumber
1999 - IRG/WP 99-30189
Recent research conducted by Forest Research, Chemcolour Industries (NZ) Ltd. and Fletcher Challenge Forest Ltd. has resulted in the development of antisapstain formulations that meet the efficacy requirements of the New Zealand Forest industry for export logs. One treatment, called Sentry®, is now poised for commercial use in New Zealand for treating export logs, having undergone an extensive su...
R N Wakeling, D R Eden, C M Chittenden, J G Van der Waals, B Carpenter, I Dorset, R Kuluz, J Wakeman
Inadequacies in preservative retention and formulation as contributory causes of premature failure of CCA-treated vineyard posts
1984 - IRG/WP 3280
Analyses of severely decayed or failed vineyard posts and examination of stake test data on effectiveness of copper-chrome-arsenate (CCA) preservatives have suggested two contributory causes of premature failure of vineyard posts: 1. Preservative retentions in posts are such that after 15 years' exposure some decay is inevitable. 2. The high arsenic, low chrome formulations with which the...
M E Hedley
Laboratory and field evaluations of a novel formulation, BAM as an anti-sapstain agent
1991 - IRG/WP 3639
A novel anti-sapstain formulation, BAM, consisting of 2-(thiocyanomethylthio) benzothiazole (TCMTB) and methylene bis thiocyanate (MBT) was evaluated for ist anti-sapstain performance in the laboratory and in the field as well. BAM proved effective in controlling the growth of molds and a sapstaining fungus in the standardized Japan Wood Preserving Association (JWPA) tests. All the test fungi coul...
An evaluation of the efficacy of a chlorothalonil formulation and a chlorothalonil plus chlorpyrifos formulation in the field
1993 - IRG/WP 93-30005
Details on the treatment of Pinus radiata D. Don and Eucalyptus regnans F. Muell. sapwood specimens to three retentions of each of two preservative formulations (chlorothalonil in oil; chlorothalonil plus chlorpyrifos in oil) and their installation below ground at three field test sites in Australia are given. Specimens were treated with each formulation to achieve 3.2, 6.4 and 12.8 kg/m³ of chlo...
J W Creffield, N Chew
Evaluation of a new anti-sapstain formulation
1994 - IRG/WP 94-30035
A new anti-sapstain mixture, which consists of 2% IPBC (3-iodo-2-propynylbutyl carbamate) and 1.5% DCOI (4,5-dichloro-2-n-octylisothiazolin-3-one), was evaluated by three methods in the laboratory. A standardized test (JWPA standard 2) demonstrated that the new anti-sapstain formulation was highly effective in controlling growth of monocultures of five test fungi on wood substrate. When exposed to...
K Tsunoda, H Kumagai, M Sakurai
Xylophene AS™, the challenge of developing a modern antisapstain formulation for the french market
2000 - IRG/WP 00-30250
In France Sodium Pentachlorophenol (NaPCP) has been used for more than 40 years for the protection of freshly cut and unseasoned lumber. The French sawmill industry requires a protection of 6 months and maximum 10% surface infection by moulds and/or sapstain fungi. However, this active substance did have some serious environmental flaws and no authorisation was granted for a direct contact of NaPC...
E Wozniak, L Cubizolles, N Delourme Fonseca, A R Valcke, J Gors
In search of excellence - A necessary challenge
1990 - IRG/WP 3567
Consumerism and environmentalism are gaining much influence. At national and E.C.-level the policy conducted is based on prevention of pollution through "sound" wood preservatives. Supposing that "environmental friendly" products do not exist it is understood that "sound" products have least effect on the environment during their whole life cycle. In the past only the effectiveness was paramount, ...
Sentry®), a new antisapstain formulation for protecting logs and lumber. - Part 1: advances in protection of New Zealand radiata pine logs
1999 - IRG/WP 99-30188
Until recently antisapstain formulations gave approximately 10 weeks protection to radiata pine logs and even within this time frame protection was often not consistent. Industry requires 20 weeks protection. The degree of protection sought by industry is in the order of 90-95%. For example, this equates to a maximum of 5 - 10% surface cover of sapstain in the first whole veneer produced from a pe...
R N Wakeling, D R Eden, C M Chittenden, J G Van der Waals, B Carpenter, I Dorset, R Kuluz, J Wakeman, T Price, B Nairn
Preservative treatment of wood-based composites with a mixture formulation of IPBC-silafluofen using supercritical carbon dioxide as a carrier gas
2003 - IRG/WP 03-40251
Wood-based composites treated with a mixture formulation of a fungicide, 3-iodo-2-propynyl butylcarbamate (IPBC) and a termiticide, silafluofen using supercritical carbon dioxide (SC-CO2) as a carrier solvent were tested for their resistance to decay and termite attack in the laboratory. The treatment solution was prepared by mixing both biocides (IPBC 10 + silafluofen 1) with a co-solvent, ethano...
K Tsunoda, M Muin
Development process of a new anti-sapstain formulation and its present status with the relevant problems
2001 - IRG/WP 01-30257
An anti-sapstain formulation, which contains 2-(thiocyanomethylthio)benzothiazol (TCMTB) and methylene-bis-thiocyanate (MBT) as active ingredients, was developed by a technical agreement with Buckman Laboratories (Memphis, TN, USA) as an alternative to chlorinated phenols for the Japanese market. The formulation was commercialized as BAM 12 years ago. As anti-sapstain treatment is commonly conduct...
K Nobashi, Y Nomura, K Tsunoda
Methods for improving preservative penetration into wood: a review
2002 - IRG/WP 02-40227
Pressure treatment technologies have been available since the mid-1830's, but the processes used for wood treatment are still largely unable to overcome the fundamental limitations of flow through semi-permeable pit membranes. Instead, methods have arisen that attempt to improve treatability of the wood including incising, compression rolling, through boring, or radial drilling. Other a...
J J Morrell, P I Morris
Migration of chlorothalonil and carbendazim in fruits stored in wood treated with the anti-sapstain formulation Tuff Brite C
1997 - IRG/WP 97-50097
Fruits and vegetables stored in treated wood boxes are in contact with the products used for the treatment. In order to obtain regulatory approval for incidental food contact it is necessary to determine the quantity of residues on these fruits or vegetables. When the active materials are used in agriculture it is required that residues found are below to the MRL fixed for these substances. In the...
J F Cooper, D Riboul, M De Vleeschauwer, T L Woods
An anti-termite formulation for soil treatment with natural products and its efficacy against Coptotermes formosanus Shiraki
2003 - IRG/WP 03-30319
An anti-termite formulation of an environmental conservation type for soil treatment was developed. The formulation was composed of decanoic acid (n-capric acid, an fatty acid derived from coconut oil with ten carbons) as an active ingredient and other natural products. Experiments to examine the efficacy of the formulation against Coptotermes formosanus Shiraki were conducted at the termite field...
S Yoshida, T Nakagaki, A Igarashi, A Enoki
Effects of boron formulation on specific timber types used in ships of historical importance
1991 - IRG/WP 3676
This paper reports results of preservative treatment and leaching experiments, using borax, polybor and boracol 20, on small wood blocks of English oak and American pitch pine heartwood. Earlier experiments on the performance of various biocides as possible additives to bilgewater to prevent fungal decay of shipping timbers had suggested that some formulations of boron might be associated with phy...
B King, G M Smith, J W Palfreyman, S McCutcheon
Protection of wood for above ground application through modification with a fatty acid modified N-methylol/paraffin formulation
2007 - IRG/WP 07-40378
Hydrophobic chemical modification can be regarded as an alternative approach to conventional wood preservation using biocides in order to protect wood in hazard class 3 according the European Standard EN 335-1. A formulation containing fatty acid modified N-methylol/paraffin and an aluminium salt catalyst was used to change the material properties of wood in order to protect wood from fungal dec...
Nguyen Hong Minh, H Militz, C Mai