Your search resulted in 459 documents. Displaying 25 entries per page.
New perspectives for wood protection: enzyme-based treatments
2016 - IRG/WP 16-40742
Wood protection research is continuously looking for more benign and effective treatments. One of the main concerns deals with the toxicity of the active compounds employed in the formulations of the preservatives, since they could become a health and environmental issue. Secondly, long-lasting treatments are preferred in order to increase the service life of the treated wood. Weathering condition...
C Fernández-Costas, S Palanti, M Á Sanromán, D Moldes
State of the art of industrial wood protection in Portugal
2016 - IRG/WP 16-30703
This work intended to give a perspective of industrial wood protection in Portugal. A survey was made of the companies treating wood mainly for use classes 3 and 4 such as autoclave treatments with biocides and wood modification procedures. Currently there are 23 companies with 33 production plants with an autoclave installed for wood preservation by impregnation. There are also two companies prod...
L Nunes, J Carmo, J Vicente, B Esteves
Wood Protection and Environmental Performance of Products - Impacts COST Action FP1407 Aims to Bring
2016 - IRG/WP 16-50323
Though many aspects of wood modification (chemical, thermal, impregnation) treatments are known, the fundamental influence of the process on product performance, the environment, and end of life scenarios remain unknown. To contribute to the low-carbon economy and sustainable development, it is essential to integrate interactive assessment of process parameters, developed product properties, and e...
A Kutnar
Prevention of fungal damage of oil and date palm wood by organic acids
2017 - IRG/WP 17-10877
Felled palm trunks are susceptible to fungi as long as their moisture content is above fibre saturation. During this period, palm wood has to be protected against mould and rot fungi. Environmental-friendly organic acids are suitable. Small samples of oil palm (Elaeis guineensis) and date palm (Phoenix dactylifera) wood were treated with 1 to 10% solutions of acetic acid and propionic acid, respec...
M Bahmani, O Schmidt
Effects of climatic factors and material properties on mould growth on untreated wooden claddings
2017 - IRG/WP 17-10884
Mould growth is an important contributor to colour change of untreated wood exposed outdoors. Predicting the development of mould growth is therefore important to ensure successful use of untreated wood as a façade material. More knowledge about the factors affecting mould growth on outdoor exposed wood is required to give better predictions. In this study, climatic factors and material propertie...
S Karlsen Lie, G I Vestøl, O Høibø, L Ross Gobakken
Fungal growth on coated wood exposed outdoors: influence of coating pigmentation, cardinal direction and inclination of wood surfaces
2017 - IRG/WP 17-10896
The objective of the SERVOWOOD project was to develop and establish European Standards that will facilitate the prediction of service life for exterior wood coatings. One of the objective of this project was to study fungal growth of the field exposed panels. Two coatings applied in 2 and 3 coats were exposed for one year outdoors at 45° south: one solventborne (alkyd based) and one waterborne (a...
L Podgorski, C Reynaud, M Montibus
Overview of the treated wood quality control program in the United States with the recent challenges and advances
2017 - IRG/WP 17-20616
In the past two decades, there have been significant and rapid changes in wood protection technologies for residential applications which have moved away from long established heavy duty metal oxide based products such as chromated copper arsenate (CCA). The successor generation of wood protection systems usually contain copper as the primary biocide, in combination with carbon-based co-biocides s...
L Jin
Ensuring Quality of Treated Wood – Regulations, Certifications and Associative Background in the Field of Wood Protection in Europe
2017 - IRG/WP 17-20626
Beside legal requirements, buyers and end-users of wood preservatives and/or of treated wood and wood-based materials may require additional warranties regarding the quality and the performance of the products available on the market. These greatly enhance the confidence of end-users and the chance for a product of being marketed with a quality label. Additionally, quality control systems and trai...
M Kutnik, M Klamer, E Melcher
Activity of Two Strobilurin Fungicides Against Three Species of Decay Fungi in Agar Plate Tests
2017 - IRG/WP 17-30704
The objective of this study was to examine the toxicity of strobilurin fungicides against wood decay fungi in order to assess their potential to act as a co-biocide for copper-based wood protection. Two strobilurin fungicides, Heritage (50% azoxystrobin active ingredient) and Insignia (20% pyraclostrobin active ingredients), and copper sulfate pentahydrate were tested against one white rot fungus...
J D Tang, T Ciaramitaro, M Tomaso-Peterson, S V Diehl
Copolymers of tannin extracts as wood protection agents
2017 - IRG/WP 17-30709
Wouldn´t be a dream to preserve wood with the substances which the nature already synthesizes for protecting itself? The idea we would like to pursue is simple: Increase the concentration of these substances, the tannins, trying to fix them properly in wood. It appears easy but it is not. Sensibility against leaching, fungal decay and weathering were observed. In this paper new flavonoid co-polym...
G Tondi, L Sommerauer, A Oberle, A Petutschnigg, M-F Thevenon
Liquefaction of woody waste: A novel approach in wood protection from CNSL based liquefied wood polyols
2017 - IRG/WP 17-30711
Liquefaction of lingo-cellulosic biomass is one of the thermo-chemical conversion processes for developing new materials, adhesives, preservatives and energy systems. The process also provides an opportunity to utilize waste wood such as saw-dust, woody wastes, branches and twigs for the development of value added products. Thus, this research paper deals with an investigation of antifungal and a...
A Kumar, G B.Nagarajappa, S Singh Chauhan
Weathering protection of European hardwoods through double modification
2017 - IRG/WP 17-30715
Beech and poplar were thermally modified, treated with melamine resin and both treatments were combined. The weathering performance (cracks and general appearance) of modified beech and poplar was assessed in natural weathering and correlated to material properties such as work in bending (WB) and Brinell hardness. In addition, the equilibrium moisture content after exposure of 12 months and subse...
G Behr, A Gellerich, S Bollmus, H Militz
Thermal stability of a wood protective biofinish and the influence of flame retardants on Aureobasidium cells
2017 - IRG/WP 17-30716
In general there is an increasing need for sustainable resources, including sustainable building materials. Wood is one of these sustainable resources and is more used as an outdoor building material. Since unprotected wood will usually be degraded during outdoor exposure, many different protection systems are available on the market. Protection systems containing biocides however might create obs...
S Rensink, E A M Klein Rot, M F Sailer
Evaluation of timber bridges with special consideration of detail design
2017 - IRG/WP 17-40781
Since 1997 the use of wood in bridge construction has been increasingly criticized by the Hamburg federal state authority supposedly because of shortened service life due to decay. With regard to wood research, however, it is often suggested that use of timber is suitable for weathered structures as long as constructive protection measures will be observed. In order to unravel the reasons for the ...
K Robbers, J Fromm, E Melcher
Plasma-assisted bleaching of blue-stain from lodgepole pine wood
2017 - IRG/WP 17-40799
We hypothesize that plasma will etch wood and fungal hyphae in blue-stained lodgepole pine, and increase the ability of hypochlorite bleach to remove discolouration from blue-stained wood. Blue-stained lodgepole pine wood was exposed to a glow-discharge plasma derived from water, and the surface wettability, permeability and colour of the treated wood was measured. Plasma-treated wood was dipped i...
A Jamali, P D Evans
Surface Protection of Wood with Metal Acetylacetonates
2017 - IRG/WP 17-40802
Metal acetylacetonates are coordination complexes of metal ions and the acetylacetonate anion. They have diverse uses as catalysts, cross-linking and curing agents and adhesion promotors. Some metal acetylacetonates can photostabilise polymers whereas others are photocatalysts. We hypothesise that the ability of metal acetylacetonates to photostabilise wood will vary depending on the metal in the ...
Yuner Zhu, P D Evans
Review on protection of timber bridges in Norway and other countries
2017 - IRG/WP 17-40809
Wood plays a major role in design and construction of modern bridges in Norway. Typical elements of those bridges are double impregnated glued laminated members, stress laminated timber decks, slotted-in steel plates, metal cladding of the surfaces of loadbearing members, and cross girders made of steel. Selected examples of timber bridges in Norway are presented. This review paper gives an overvi...
K-C Mahnert, U Hundhausen
Functional silicones used for wood protection: preliminary study
2017 - IRG/WP 17-30720
Due to worldwide regulation the wood preservation domain is constantly changing. Silicones are used for different industrial applications as hydrophobic agents. This property could enable to reduce water uptake of wood treated with these compounds. Treated wood could then be less prone to dimensional variation and fungal attack, those parameters being driven by variations in wood’s moisture cont...
C Reynaud, F Marchal, F Pochon, M Kutnik
UV-curable coatings developed for aesthetic and biological protection of wood outdoors
2017 - IRG/WP 17-40821
To avoid wood greying, dimensional variations, and degradation by biological agents wood is protected with preservation products and coatings when used outdoors. For some wood species used for cladding, a treatment with a preservation product is required, and is frequently additionally protected with a coating. In this study, Mäder Group developed a new UV-curable coating for outdoors application...
C Reynaud, A S Schuller, M Kutnik, L Podgorski
Biocontrol of wood decay insects and nematodes as an alternative to traditional chemical treatments
2018 - IRG/WP 18-10914
The protection of wood has been defined until relatively recently, as the application of a chemical to increase its durability. On the other hand, society is becoming more and more demanding in terms of the use of products which have the minimum ecological impact. This has led many countries to reduce the list of biocidal products that can be used (European Biocides Regulation), therefore it is ne...
L Robertson, J F Galván, F Llinares, R Viñambres, M T de Troya
Liquefied wood polyols: Ecofriendly bio-based preservative for sustainable protection of wood from Termite attack
2018 - IRG/WP 18-10916
The major problems encountered in both indoor and outdoor utilization of wood are biological decay due to termite. The modification of wood with liquefied wood polyols has been found to be effective against termite attack. The liquefaction of wood aims to utilize woody wastes which are being generated during primary and secondary processing of wood in wood based industry. One of promising approach...
A Kumar, A John, T S Mehra, A K Pandey, S Singh Chauhan
Hibernation or spring awakening? – The research on wood durability and protection in marine environment
2018 - IRG/WP 18-10929
Wooden structures in marine applications are exposed to severe degradation conditions caused by mechanical loads and wood degrading organisms. The present paper presents the use of wood in marine environments in Europe from a wood protection perspective and gives an overview over relevant research topics. It compiles the most relevant literature with an emphasis on new wood protection methods and ...
A Treu, K Zimmer, C Brischke, E Larnøy, L R Gobakken, F Aloui, S M Cragg, P-O Flæte, M Humar, M Westin
Superior kempas hardwood protection with two proprietary microemulsion termiticdes based on permethrin and cyermethrin against Coptotermes termite attack under H2 an H3 weathered conditions found in buildings
2018 - IRG/WP 18-10931
SARPECO® and AXIL® solutions are water-based wood preservatives approved for dipping treatment providing 25 years of termite protection for solid wood and wood-based products in Europe and for more than 10 years in Indonesia. SARPECO® and AXIL® solutions are patented formulations based on concentrated microemulsions (ME) diluted with water as a dipping treatment but also for vacuum pressure tr...
D Messaudi, A H H Wong, C A D Tawi, N Bourguiba, O Fahy
Liquefied wood polyols: a bio-based preservative for protection of wood from fungal decay
2018 - IRG/WP 18-30725
The liquefaction of wood is one of promising approaches in utilization of woody waste which is generated during primary and secondary processing of wood and liquefied wood having various application including bio-based preservatives. The biological degradation of wood due to fungi is the major problem encountered in indoor and outdoor utilization of wood. In this study, woody waste recovered from ...
A Kumar, G Vijaylakshmi, S Singh Chauhan
Effects of wood protecting biofinish and linseed oil on fire behaviour and leachability of the fire retardant
2018 - IRG/WP 18-30728
A wood protecting biofinish is based on a protective and decorative fungal-based coating and a linseed oil impregnation (called Xyhlo biofinish). This biofinish enables the long-term use of wood in outdoor applications without using toxic chemicals.
The fire resistant properties of materials used in buildings are very important. Since Xyhlo biofinish is relatively new, only little information is ...
S Rensink, E J van Niewenhuijzen, M F Sailer